SPECK Mechanical Seal M3N/101-14(R26 S25)
People who bought this item also viewed
KSB Mechanical Seal KSB2-028
ROTEN Mechanical Seal ROTEN-5-40-X
STAIRS Water Pump CBK8-30/3
Repair Kit for Isuzu 4LE2
TTO Oil Seal TC 35*75*10
Customers frequently viewed
IWAYA DENKI Water Pump 25CJT0752
Panasonic Servo Motor MHMF022L1V2M
Honeywell Solenoid Valve VE4025B1045
ROTEN Mechanical Seal 8E5K-22-X
SANDSUN Overload Pump VA08H-760
GS Battery 6-QW-60(450)-(55D23L-KR)
Rechi Compressor 44R273A
MINDMAN Air Cylinder MCQV2-11-40-200
Mitsubishi Compressor YB645WTG
Yaskawa Servo Motor SGM-04AWSU12
Carel Temperature Controller RITCUSRG02
Eaton Vickers Vane Pump V10-1S4S-1A20
Honeywell Sensor TBPDPNS001PGUCV
Recent related posts
-
07/18/2020
Calculation formula and calculation guide for industrial chillers
Low-temperature chiller refrigeration system operating conditions and adjustments Nowadays, chillers are widely used in the refrigeration industry, and the refrigeration working fluid is usually R22 (also R404a) and so on. In order to facilitate operation and maintenance and reduce the installation location, the refrigeration compressor
-
08/25/2020
Renovation of the small turbine of the propylene refrigeration compressor oil station of the DCC unit has achieved initial results
Recently, the technicians of the DCC device have undergone transformation. The temperature of the small turbine bearing box of the propylene compressor oil station of the device has dropped from 90-120 degrees Celsius to 70-85 degrees Celsius
-
09/11/2020
Electric valves have the advantages of easy assembly and low failure rate, becoming the mainstream of the market
In terms of operating efficiency and saving energy consumption, the use of automatic control valves is an indispensable part. The manual valves and pneumatic valves commonly used in traditional industries are not as good as electric valves in terms of installation cost and efficiency.
-
05/14/2022
What Are The Input And Output Module (I / O) of PLC?
PLC I/O is the part of the PLC that connects the brain of the PLC, the CPU, to the outside world, the machines.
-
09/08/2020
The difference between air-cooled and water-cooled screw air compressors
The difference between air-cooled screw machine and water-cooled screw machine: The oil cooler of the air-cooled screw compressor and the compressed air after-cooler are made into one body. It is an aluminum plate-fin structure and brazed in a vacuum furnace. Once the oil leaks, it is almost irreparable and only replaced. The working principle is that hot oil and high temperature (about 80℃) gas flow in their respective pipes,
-
03/18/2021
The working principle and the common wiring method of the servo drive
The servo drives, the motor under the command signal from a control system, so whether the drive can work normally or not directly affects the overall performance of the equipment. In the servo control system, the servo drive is equivalent to the brain, and the servo motor is equivalent to the hands and feet.
-
01/09/2022
Heat Pump Compressor Troubleshooting
There are various types of compressors used in the heat pump unit and the fully enclosed piston compressor is the most commonly used type. However, when it’s in winter, there most probably are faults of this type of compressor due to frequent heating operations.
-
08/21/2020
What are the hazards caused by the air entering the condenser of the freezer
The handling of water-cooled chiller failures must strictly follow scientific procedures. The chiller operator should not act without authorization and disassemble the water-cooled chiller at will when the situation is unclear,
-
07/09/2020
Global Centrifugal Compressor Market Market: Revenue Growth and Applications Insights
The Global Centrifugal Compressor Market Market Research Report 2020 published by Prophecy Market Insights is an all-inclusive business research study on the current state of the industry which analyzes innovative strategies for business growth and describes significant factors such as top developers/manufacturers
-
08/20/2020
The general layout principle of the suction pipe in the cold storage
Recently, a small partner left a message asking about the general layout principles of the suction pipe in the cold storage. Today, the editor of okmarts.com will popularize this knowledge for everyone