Contrinex Sensor DW-AS-514-M8-001

09/11/2020

Bearing and shaft fit tolerance standard

Bearing and shaft fit tolerance standard ①When the bearing inner diameter tolerance zone and the shaft tolerance zone form a fit, the tolerance code originally belonging to the transition fit in the general basic hole system will become an over-win fit, such as k5, k6, m5, m6, n6, etc., but the over-win amount is not Large; when the bearing inner diameter tolerance is matched with h5, h6, g5, g6, etc., it is not a clearance but an over-win fit.

06/29/2020

What is the cause of compressor pipeline vibration

08/11/2020

5 key points of central air conditioning installation

Central air-conditioning installation is a very high-end technology. I don't dare to install central air-conditioning without a few years of experience.

08/13/2020

Maintenance of automobile air conditioning control system

When troubleshooting and overhauling the automotive air-conditioning control electrical system, the specific failure phenomena should be observed and the possible failure locations should be analyzed to avoid blindness in overhaul.

08/20/2020

Selection and design of cold storage doors

Under normal circumstances, the cold storage door as one of the cold storage equipment only accounts for less than 10% of the entire system cost. After the entire system is put into use, it has almost become the "front" of the entire system.

08/09/2020

Causes and solutions of leakage in heating construction

In the heating construction process, leakage is a relatively common quality problem. Once leakage occurs, it will have a greater impact on people's normal production and life, and at the same time,

06/14/2020

Broken refrigeration compressor bearings? What can be repaired? Which must be thrown?

Broken refrigeration compressor bearings? What can be repaired? Which must be thrown? How to judge whether the bearing can be used again and the defects of the bearing need to be replaced To determine whether the bearing can be used again, it should be 器2䀀
ￜ皥
䖒皦즠Ʋ嫜ི㲈Ʋ
䌁皦
ᮔDž༬皧嫦ིЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥巠皱㙲皦抐皱巠皱੨皦柘皱

07/19/2020

Energy Adjustment of Refrigeration Compressor of Industrial Refrigerator

Energy Adjustment of Refrigeration Compressor of Industrial Refrigerator In addition to the intermittent operation of the compressor, the energy adjustment of the refrigeration compressor of an industrial refrigerator can also be achieved by changing the passage area of ​​the compressor suction stop valve. If the area of ​​the cut-off valve channel of the refrigeration compressor of the industrial chiller is reduced, the flow resistance of the suction steam will increase, and the steam will be throttled, resulting in a corresponding decrease in the pressure of the suction chamber,

08/03/2020

What is the difference between an air source heat pump and a heating and cooling air conditioner

According to statistics, in 2017, a total of 5.78 million households were converted from coal to electricity and gas, and 3.94 million households were completed in 28 cities in Beijing-Tianjin-Hebei and surrounding areas.

08/18/2020

Solution to water leakage of fan coil ceiling

The fan-coil system is supplied with chilled water by the chiller, and the water temperature is usually only about 8°C. Therefore, the chilled water supply and return pipes, condenser pipes and condensate trays are all relatively low in temperature.