MITSUBOSHI Belt A-94

09/05/2020

Who has the final say on equipment shutdown for maintenance

In enterprises, the equipment should be subject to preventive maintenance. According to the set cycle, the equipment should be shut down for repair. Usually production scheduling has the final say.

06/14/2020

Ten basic performance parameters of refrigeration compressors (technical sharing)

Ten basic performance parameters of refrigeration compressors (technical sharing) 1. Actual gas transmission volume (referred to as gas transmission volume) 　　 Under a certain working condition, the mass of gas delivered from the suction end to the ex器2䀀
ￜ皥
䖒皦즠Ʋ嫜ི㲈Ʋ
䌁皦
ᮔDž༬皧嫦ིЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥巠皱㙲皦抐皱巠皱੨皦柘皱ￜ皥
ب巠皱㙲皦忈皱੨皦柘皱
즠Ʋǜ勁皦즠ƲبǜV /펔B䌁皦

08/20/2020

Operation management of wet stroke of refrigeration compressor

The wet stroke of the compressor is caused by the liquid refrigerant entering the cylinder. When the amount of liquid entering is small, frost will form on the outside of the cylinder.

06/29/2020

Suggestions for troubleshooting of compressor with liquid start

09/23/2020

Application of DCS system in anti-surge control system of air separation compressor

Keywords: DCS system, air separation compressor, anti-surge control system Preface 　　 The 6000m3/h air separation plant of Xilin Iron and Steel Company was completed in May 2001 by Hangzhou Oxygen Concentrator Group Company. The factory design was designed by Beijing Iron and Steel Design Institute. It was successfully put into operation on September 2, 2001, and it took more than half a year to run. It shows that the unit is operating stably, and all indicators have reached or exceeded the design value. The entire control system uses Honeywell’s TDC3000 and two GUS stations.

08/16/2020

How to use a water-cooled chiller with a cooling tower for the best effect

A cooling tower is a device that cools water. It is often used in the process of high-speed operation of water-cooled chillers. The cooling tower is a fully functional heat dissipation device to ensure the efficient and stable operation of the water-cooled chiller.

08/14/2020

Four major reasons for the reduction of efficiency in the use of industrial chillers

Industrial chillers are often inefficient when they are in use, and there are many reasons for this phenomenon. Not only because of the environment in the chiller factory, but also because of the loss of components when the equipment itself is used for a long time

06/14/2020

Centrifugal refrigeration compressors are mainly used for air conditioning in large buildings, Less demand.

Centrifugal refrigeration compressors are mainly used for air conditioning in large buildings, Less demand. In recent years, large-scale infrastructure projects have been launched, and centrifugal refrigeration compressors have become a hot spot of concerﰸ2䀀
ￜ皥
䖒皦즠Ʋ娼ི㲈Ʋ
䌁皦隆
ᮔDž༬皧婆ིЀ呄ᠾ鹨់༹皧
ࠄ
00븹먱댁珵理뛐珵Љ
䕄ྦ￿￿뤂ᐱ變뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់變ᩄꋔྦ
瑉浥

06/03/2025

Reasons and necessity of overhaul of oil-injected twin-screw air compressor

The structure of the main engine (also known as the head) of an oil-injected twin-screw air compressor is usually composed of a pair of mutually meshing screws, main engine casing, high-pressure end and end cover, and low-pressure end and end cover.

08/03/2020

Why do air conditioners, refrigerators, washing machines, etc. use three-wire plugs

Three-wire plug: neutral wire, live wire, ground wire. The ground wire belongs to the type of leakage protection! High-power electrical products are protected by three-phase plugs