Repeatability: ±0.2% FS
Turndown Ratio: 200:1
Control Response Time: 100 ms
Input Control Signal: 0 to 5 Vdc, RS232
Output Signal: 0 to 5 Vdc, RS232
Optional Input/Outputs: 4 to 20 mA, 0 to 10 Vdc
Operating Temperature: -10 to 50°C (14 to 122°F)
Zero Shift: 0.02%/ATM FS/°C
Span Shift: 0.02%/ATM FS/°C
Humidity Range: 0 to 100% RH, non-condensing
Excess Flow Rate: 2.4% FS
Wetted Materials: 303 and 302 SS, FKM, heat cured silicone
RTV (rubber), glass-reinforced PPS, heat cured epoxy,
aluminum, gold, silicone, glass; >250 SLM: 416 SS and nickel
replace brass
Maximum Pressure: 145 psig
To Use in Volumetric Mode: Near atmosphere, 15 psig
recommended maximum. Volumetric flow meters and
controllers not certified for accuracy at mass flow rates above
the rated flow range of the meter. They are designed for near
atmospheric pressure conditions only. The recommended
maximum operating pressure is 15 psig
Minimum Differential Pressure Required:
5 SLM and under: 5 psid; 10 to 250 SLM:
15 psid; 500 SLM: 5 psid; 1500 SLM: 10 psid
Supply Current: 0.250 A for 20 SLM and
under; 0.75 A for 50 SLM and above (typical)
Supply Voltage: 12 to 30 Vdc for units
20 SLM and smaller; 24 to 30 Vdc for units 50 SLM and larger
Electrical Connections: 8-pin circular mini DIN
Omega Flowmeter FMA-2621A-V2
People who bought this item also viewed
FineTek Level Meter SA110ADQ
HANNA Turbidity Meter HI88703-01
Customers frequently viewed
IWAYA DENKI Water Pump 25CJT0752
Panasonic Servo Motor MHMF022L1V2M
Honeywell Solenoid Valve VE4025B1045
ROTEN Mechanical Seal 8E5K-22-X
SANDSUN Overload Pump VA08H-760
GS Battery 6-QW-60(450)-(55D23L-KR)
Rechi Compressor 44R273A
MINDMAN Air Cylinder MCQV2-11-40-200
Mitsubishi Compressor YB645WTG
Yaskawa Servo Drive CACR-SR03AD1KR
NORGREN Air Cylinder RT/57120/MC/25
CRYDOM Relay XBPW6025
Recent related posts
-
07/18/2020
Calculation formula and calculation guide for industrial chillers
Low-temperature chiller refrigeration system operating conditions and adjustments Nowadays, chillers are widely used in the refrigeration industry, and the refrigeration working fluid is usually R22 (also R404a) and so on. In order to facilitate operation and maintenance and reduce the installation location, the refrigeration compressor
-
08/04/2020
Analysis of five major problems in current heating management
With the development of society and the continuous improvement of people's living standards, traditional heating methods and management models have become less and less suitable for the development of the times.
-
09/20/2020
Rolling bearing technology
Rolling bearing technology Rolling bearing temperature <br></br> The main factors of bearing operating temperature:
-
06/13/2020
Common failure causes of half-sealed piston compressor
Common failure causes of half-sealed piston compressor 1. The compressor cannot start normally 1. First check whether it is caused by too low power supply voltage or poor connection of the motor line: if the grid voltage is indeed too low, start again 器2 䀀 ᅵ皥 䖒皦즠Ʋ焬क़ 㲈Ʋ 䌁皦 ᮔDž༬皧然क़Ѐ 呄ᠾ鹨់༹皧 ࠄ 00령ꐱ댁珵뛐珵Љ 䕄ྦ 뤂ᐱ뚜珵 ᴴᏩ呄ᠾ퍘ᒥ 鹨់ᩄ ꋔྦ 瑉浥 巠皱㙲皦抐皱 巠皱 ੨皦柘皱 ᅵ皥 ب 巠皱㙲皦忈皱 ੨皦柘皱 즠Ʋǜ 勁皦즠Ʋب ǜ V / 펔B䌁皦 ᮔDž '鱤džၜ먢䇨珵呈ᠾ뤂ᐱ ⿇⬿먲僧ᐱ㥲ᐲ�僬㣢ᐲ ᠾ 랖僧Ӛ 識 �僬㣢ᐲ 臆S㥲ᐲ ᬄğ 識 理艏S杴 識杴 㥲ᐲ
-
01/12/2021
Mitsubishi Heavy Industries air conditioning and Daikin which is better
Mitsubishi Heavy Industries and Daikin are both well-known Japanese companies. The following is a brief introduction to the background of the two companies: First, Daikin Air Conditioning is an old-brand industry in Japan. It has been the owner since 1924 器2 䀀 ᅵ皥 䖒皦즠Ʋ奌ི 㲈Ʋ 䌁皦 ᮔDž༬皧奖ིЀ 呄ᠾ鹨់༹皧 ࠄ 00령ꐱ댁珵뛐珵Љ 䕄ྦ 뤂ᐱ뚜珵 ᴴᏩ呄ᠾ퍘ᒥ 鹨់ᩄ ꋔྦ 瑉浥 巠皱㙲皦抐皱 巠皱 ੨皦柘皱 ᅵ皥 ب 巠皱㙲皦忈皱 ੨皦柘皱 즠Ʋǜ 勁皦즠Ʋب ǜ V / 펔B䌁皦 ᮔDž '鱤džၜ먢䇨珵呈ᠾ뤂ᐱ ⿇⬿먲僧ᐱ㥲ᐲ�僬㣢ᐲ ᠾ 랖僧ي 識 �僬㣢ᐲ 臆S㥲ᐲ ᬄğ 識 理艏S杴 識杴 㥲ᐲ
-
09/22/2023
Water-Cooled Chiller vs Air-Cooled Chiller: Which One is Better?
When it comes to cooling systems for large commercial buildings or industrial facilities, two of the most common options are water-cooled chillers and air-cooled chillers. Both types of chillers are designed to remove heat from a building or industrial process, but they operate in different ways and have their own unique advantages and disadvantages.
-
08/10/2020
How to choose refrigerant for high and low temperature alternating damp heat test chamber
There are many kinds of refrigeration used in the high and low temperature alternating damp heat test chamber, and different refrigerants have very different uses and application ranges. Today, we will focus on explaining the main refrigerants on the market.
-
08/17/2020
Why can't the cold storage temperature drop The evaporator is very important!
There are many reasons why the temperature of the cold storage cannot drop. The editor of okmarts.com lists the following six common phenomena for your reference:
-
09/03/2020
What is the maximum flow condition of a centrifugal compressor
The working condition when the flow reaches the maximum is the maximum flow working condition. There are two possibilities for this working condition:
-
07/01/2020
Precautions for the use of screw air compressor oil
Precautions for the use of screw air compressor oil Precautions for the use of screw air compressor oil: It is forbidden to mix air compressor oils of different brands and grades. The old oil must be drained when replacing. It is strictly forbidden to add or filter and reuse. Because although the color of the compressor oil does not change on the surface, the consumption of additives may have exceeded the limit.