Baumer Sensor FLDK 110G1003/S14

08/11/2020

What is the cause of the sudden cold and hot condenser

Analysis of the reasons for the sudden cold and hot condenser:<br></br> 　　 1. There is a partial blockage in the capillary.<br></br> 　　2. There is partial blockage in the filter dryer

08/11/2020

Refrigerant classification and selection requirements

Refrigerants are also called refrigeration working fluids, commonly known as refrigerants in some areas in the south. It is a working substance that continuously circulates in the refrigeration system and realizes refrigeration through its own state changes.

09/09/2020

Various common problems of screw air compressor maintenance

1.What are the maintenance methods for screw air compressor motors? The operating environment of the motor should always be kept dry, the surface should be kept clean, and the air inlet should not accumulate dust, fibers and other debris.

06/29/2020

Several causes of compressor burning

03/13/2021

Working principle of servo drive

At present, most servo drivers use digital signal processor (DSP) as the control core, which can achieve more complex control algorithm, digitalization, networking and intellectualization. The drive circuit based on intelligent power module (IPM) is widely used in power devices.

07/16/2020

How to see if the refrigerant leaks in the high and low temperature test chamber

How to check whether the refrigerant leaks in the high and low temperature test box; the standard high and low temperature test box and the constant temperature and humidity test box are all selected by the air-cooled compressor, and the working principle is the same as that of the air conditioning refrigeration

07/14/2020

What's wrong with the freezer not cooling

1. Test the power cord with an electric pen. The broken power cord of the freezer is also a cause of non-refrigeration. For this situation, we need to check whether it is a power problem. The general approach is to open the door and observe whether the lighting lamp in the box Light up. Look for signs of damage to the wires, such as being bitten by a mouse.

09/11/2020

Bearing and shaft fit tolerance standard

Bearing and shaft fit tolerance standard ①When the bearing inner diameter tolerance zone and the shaft tolerance zone form a fit, the tolerance code originally belonging to the transition fit in the general basic hole system will become an over-win fit, such as k5, k6, m5, m6, n6, etc., but the over-win amount is not Large; when the bearing inner diameter tolerance is matched with h5, h6, g5, g6, etc., it is not a clearance but an over-win fit.

08/13/2020

How to install the cold storage air curtain How much do you know about these technologies

The function and technology of installing the air curtain above the cold storage door, we must first understand why the cold storage needs to install the air curtain. The air curtain prevents the convection of indoor and outdoor air,

01/11/2021

Japan Daikin, Hitachi and Mitsubishi Electric air-conditioning compressor comparison

First, take a look at Daikin. The use of high and low pressure cavity scroll compressor and swing compressor