Balluff Sensor BES04JH

08/15/2020

What should I do if the refrigeration equipment does not operate normally

Nowadays, in order to prevent the goods from selling well and causing economic losses, more and more businesses are using Xuzhou refrigeration equipment to store excess goods or sell them in anti-seasonal times.

04/16/2022

How Does Electromagnetic Flowmeter Work?

Electromagnetic flowmeter can be used for volume flow measurement of water. It not only has the advantages of small pressure loss and large measurable range, but also has simple structure and stable performance.

04/28/2022

Classification of Surge Protection Device?

Now there are all kinds of surge protection devices on the market. Among those protection products, what kind of products do we need? What should we rely on to distinguish types? Let’s see it follow Okmarts.

06/29/2020

Suggestions for troubleshooting of compressor with liquid start

08/09/2020

How to debug the small cold storage during installation

1. Installation technology of expansion valve for small cold storage 　　 1. Check whether the temperature sensor is in good condition before installation; 　　2. The installation position of the expansion valve must be close to the evaporator, and the valve body should be installed vertically, not inclined or upside down;

08/18/2020

Eight aspects allow the chiller to achieve energy saving in management

How does the chiller achieve energy saving in management, so that enterprises can save costs. In fact, there are many solutions, in addition to operation, and then in management. The following editor will give you a detailed introduction.

08/02/2020

Basic principles of data center cooling and energy saving solutions

Each data center has its own characteristics, so there is no technical solution that can be applied to any data center. This document mainly discusses some basic principles and technical issues in data center cooling and energy saving.

07/29/2020

Pressure controller use and adjustment

Many pressure controllers are used in the refrigeration system, and the pressure is controlled by the on and off of the contacts. Mainly include high pressure pressure controller, low pressure pressure controller, high and low pressure pressure controller, pressure difference controller and oil pressure protection pressure controller.

06/29/2020

Analysis of the cause of excessive suction temperature of compressor

Analysis of the cause of excessive suction temperature of compressor The high suction temperature is mainly due to the increase of superheat of suction. Note that high suction temperature does not mean high suction pressure, because the suction is superheated steam. Under normal circumstances, the compressor cylinder head should be half cold and half hot. If the suction temperature is too high, the cylinder head will all heat up.

03/05/2025

Bad-Variable-Valve-Timing-Solenoid-Symptoms-and-How-to-Replace-It

Variable Valve Timing (VVT) systems are crucial components in modern engines, optimizing performance, fuel efficiency, and emissions.