Bristol Compressor H29B24UDBVY

06/29/2020

Several causes of compressor burning

06/20/2020

How to properly clean the air conditioner yourself

After a winter of inactivity, the air conditioner that has been "dusted" for a long time is reactivated. It is believed that most of the friends are directly plugged in and turned on. In fact, this is not correct. <img src="{{media url=&quot;How_to_properly_clean_the_air_conditioner_yourself.jpg&quot;}}" alt="" /> It is necessary to know that the air conditioner has accumulated dust and breeds bacteria after being left for a long time. Blowing out with the wind seriously threatens your health. This is actually due to the working principle of the air conditioner: when cooling, the room temperature air is continuously sucked in, filtered by the filter, and then cooled by the fins of the heat exchanger, and finally the cold air is blown out, and then returned to the room for reciprocating circulation.

08/02/2020

Principle and maintenance method of air conditioner pressure protector

In addition to window air-conditioning units, many air-conditioning systems use high-pressure and (or) low-pressure pressure protectors to protect the compressor in the event of a system failure. During the normal operation of the device

07/31/2020

How to use refrigerant to empty the air conditioner after installation

Air, moisture and impurities contained in the air will cause pressure increase, current increase, noise increase, and power consumption increase in the air conditioner system, which will reduce the cooling (heat) capacity, and may also cause ice blockage and dirty blockage.

08/18/2020

How to solve the problem of too high compression ratio of chiller

In the process of using industrial chillers, various problems will inevitably occur. Due to the structure of the industrial chiller, once the compression ratio of the compressor is too high, it will affect the working efficiency of the industrial chiller.

03/03/2021

Control mode of servo motor

Torque control: the torque control mode is to set the external output torque of the motor shaft through the input of external analog quantity or the assignment of direct address. For example, if 10V corresponds to 5nm, when the external analog quantity is set to 5V, the output of the motor shaft is 2.5nm: if the load of the motor shaft is lower than 2.5nm, the motor will rotate forward, and when the external load is equal to 2.5nm

06/23/2022

How to Test a Transformer?

Transformers are an electrical component that transmit electrical energy between at least two circuits. Transformers regulate the voltage in circuits, but in some cases these can go bad and cause a circuit to not work.

07/09/2020

Air Compressor Market 2020: Overview and Share Forecasted to 2026

The research report on air compressor market offers a thorough understanding on this industry with significant details subject to its overall foothold in the global landscape and its application across major end-user industries and sectors.

08/20/2020

What are the factors that affect the cooling capacity of the chiller

A normal running chiller will always encounter a series of small problems after working for a period of time. The following is a brief description of the problem that affects the cooling capacity of the chiller. The influencing factors are as follows:

07/13/2020

All basic knowledge of screw air compressor

Danfoss logo (Danfoss) only uses unique red. The (Maneurop) logo is printed on the bottom of the piston compressor label. The nameplate is printed with visible pre-cut lines. If the nameplate is removed, the four corners of the nameplate will be missing.