Copeland Compressor ZB56KC-TW5

08/11/2020

Precautions for power distribution of screw chillers

1. After the screw chiller arrives at the customer site, it is necessary to connect the power cord to the unit control cabinet. The inlet of the control cabinet is above the control cabinet.

06/29/2020

What is the cause of compressor pipeline vibration

12/09/2022

How to Calculate the Service Life for Linear Guideways?

When the linear guideway is under load and moves, the surface of the ball track and the steel ball are constantly subjected to cyclic stress.

08/14/2020

Common failures of cold storage compressors and on-site countermeasures

The cold storage compressor is a machine used to increase gas pressure and transport gas. From the energy point of view, the cold storage compressor is a machine that converts the power energy of the prime mover into gas pressure energy.

06/14/2020

Characteristics of fin heat exchanger

Characteristics of fin heat exchanger The heat transfer efficiency is high. The disturbance of the fins to the fluid causes the boundary layer to continuously rupture, which has a large heat transfer coefficient. At the same time, because the separator a器2䀀
ￜ皥
䖒皦즠Ʋ娼ི㲈Ʋ
䌁皦
ᮔDž༬皧婆ིЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥

09/02/2020

The latest edition of compressed air purification terms (Chinese-English + paraphrase)

1 Scope 　　 is suitable for general purpose compressed air purification field, other purposes (such as medical treatment, breathing, etc.) and compressed gas purification terms can be implemented by reference.

08/24/2020

Reason analysis of refrigeration compressor can not start or stop soon after start

1) First check the main circuit. Whether the power supply has power, whether the voltage is normal, whether the fuse has been blown due to starting overload, whether the air switch has tripped, whether the switch contacts are good, and whether the power supply is missing phase. Observe the voltmeter and ammeter when starting. When the small-scale refrigeration and air-conditioning equipment does not have an ammeter or electric meter, a multimeter or electric pen can be used to check the power supply. When the power supply voltage is too low, the compressor will not start.

08/02/2020

Treatment method after load damage of screw chiller

First of all, we must confirm whether the compressor load has been burned or the components have been worn away. If so, the refrigerant system will inevitably be contaminated. For example, residual refrigerant oil remains in the pipeline after carbonization

07/21/2020

How to protect the refrigeration compressor, you must master the following knowledge!

When the compressor is running, some abnormal conditions may occur, such as: exhaust pressure is too high, suction pressure is too low, oil pressure is insufficient, motor is overheated, excess liquid enters the cylinder, etc. In the event of an abnormal situation, the compressor will be damaged if there is no protective measure.

07/05/2020

Why is frost formed between the electronic expansion valve and the compressor

Why is frost formed between the electronic expansion valve and the compressor? A customer asked: The compressor is suddenly not cooling, and the electronic expansion valve is frosted to the compressor. Is there any relationship between the two before?