Danfoss Compressor SH120B3ABQ

09/08/2020

How to choose an air compressor for nitrogen generator

The compressed air source required by the nitrogen equipment of the nitrogen production mechanism must be a dry, oil-free and clean compressed air source that requires a pressure above 0.6Mpa and below 0.8Mpa.

06/16/2020

Shinmatsu A certain customer regulation system Developmental electric compression line equipment line item officially introduced and used

Shinmatsu A certain customer regulation system Developmental electric compression line equipment line item officially introduced and used Flame flame summer day, the most painful period of time, incredible time, celebrating the baptism, small time trai器2䀀
ￜ皥
䖒皦즠Ʋ㉄ᰙ㲈Ʋ
䌁皦
ᮔDž༬皧㉎ᰙЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿

09/11/2020

High exhaust temperature is the most common failure of screw air compressors

High exhaust temperature is the most common failure of screw air compressors, and its harm is also greater. Long-term operation of equipment under high exhaust temperature conditions mainly has the following hazards:

04/04/2025

Solenoid Valves on KOBELCO Excavators: Locations, Functions, Error Codes and Troubleshooting Methods

When KOBELCO excavator displays error codes starting with D and E, such as D012 and E013, they are a solenoid valve problem.

06/23/2020

Which refrigerator is better for cooling

Different cooling methods of refrigerators have different advantages, mainly depending on which cooling method is selected. The direct cooling refrigeration type is cheap, relatively energy-saving, and has good fresh-keeping and moisturizing properties, but the temperature is uneven, and it needs to be defrosted frequently.

07/27/2022

Classification of Vane Pumps

During a rotation cycle, the volume between adjacent vanes changes because of the rotor’s eccentric mounting position. This creates the pumping action.

06/14/2020

The common oil shortage failures of scroll refrigeration compressors are here

The compressor has been short of oil for a long time-the mechanism and the friction pairs are overheated, resulting in bearing sintering and shaft holding. The compressor is short of oil for a short time-the mechanism and the friction pairs are abnorma器2䀀
ￜ皥
䖒皦즠Ʋ焬क़㲈Ʋ
䌁皦

07/18/2020

Exhaust gas of refrigeration compressor is overheated. Are these reasons caused

Compressor: It is a complex machine running at high speed. Ensuring adequate lubrication of moving parts such as compressor crankshafts, bearings, connecting rods, pistons, etc. is the basic requirement for maintaining the normal operation of the machine. For this reason, compressor manufacturers require the use of specified grades of lubricating oil, and require regular inspection of the lubricating oil level and color

06/29/2020

Suggestions for troubleshooting of compressor with liquid start

08/02/2020

What should I do if the geothermal exhaust valve leaks

Water leakage from the geothermal exhaust valve is very common. Under normal circumstances, when the heating is first delivered in winter, the geothermal pipe needs to be exhausted so that the exhaust can make the heating of the underfloor heating loop uniform.