Danfoss Compressor SM110A4VC

08/05/2020

Attention points of refrigeration compressor overload protector during use

We have tried our best to introduce a lot of professional refrigeration knowledge to you in the nearly one year. In this article, we will focus on introducing the precautions during the use of the refrigeration compressor overload protector.

07/18/2020

reasons why the constant temperature and humidity test chamber does not cool

1. Introduction The phenomenon that liquid refrigerant and/or lubricating oil damage the suction valve plate when the gas is sucked into the cylinder of the compressor, and it is produced when the piston is compressed when the piston is close to the top dead center and is not quickly discharged during the exhaust process after entering the cylinder.

07/07/2020

Earth Hour: Hitachi Central Air Conditioner works with you to speak for the earth

08/13/2020

What are the thermal state parameters of the refrigerant

In the refrigeration cycle, the working fluid continuously changes its thermal state. The physical quantity describing the thermal state of the working fluid is called the thermal state parameter of the working fluid

07/21/2020

Ten basic performance parameters of refrigeration compressors (technology sharing)

　　Under a certain working condition, the gas mass delivered from the suction end to the discharge end per unit time is called the compressor mass air delivery under this working condition, and the unit is. If calculated according to the volume of the inhalation state, the volume of the air delivery is, and the unit is then

04/26/2022

How to Install A Surge Protection Device?

Set power line surge protection device at the entrance of the line into the building, the interface of the lightning protection area and the place close to the protected equipment.

08/06/2020

Refrigeration equipment design the role of solenoid valves, thermal expansion valves, four-way valves, gate valves, and butterfly valves

Electromagnetic valve (Electromagnetic valve) is an industrial equipment controlled by electromagnetic. It is an automation basic component used to control fluid. It is an actuator and is not limited to hydraulic and pneumatic.

08/20/2020

How to use small cold storage in summer with good energy saving effect

Summer is the peak period for cold storage installation. When many people in the food-related industries are ready to consider cold storage installation, there are many factors to consider when installing cold storage in summer

08/25/2020

Precautions for showcase

1. After the cabinet is moved, it must be placed securely and stand still for half an hour before it can be powered on. When using a supermarket display cabinet for the first time, let the empty cabinet run for 2 hours before putting the food in the box for storage.

06/14/2020

Method and procedure of replacing refrigeration compressor

1. Cut off the power supply: before replacing the compressor, be sure to cut off the power supply of the unit, otherwise there will be a risk of electric shock. When removing the power supply of the compressor, the identification of each wire and the corr器2䀀
ￜ皥
䖒皦즠Ʋ嫜ི㲈Ʋ
䌁皦
ᮔDž༬皧嫦ིЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄