Danfoss Compressor SM120T6PBU

06/14/2020

11 common protection devices for refrigeration compressors

11 common protection devices for refrigeration compressors When the compressor is running, some abnormal conditions may occur, such as: the discharge pressure is too high, the suction pressure is too low

06/25/2020

What refrigerator is used for cooling

Most of them use fluorine-free refrigerants, and the models include R600A, R410A, R407A, R134A, etc., which are all green and environmentally friendly. The specific models are marked on the nameplate on the rear side of the refrigerator. the way.

06/29/2020

How the compressor works

08/17/2020

Buy a heat pump water heater, remember to pay attention to the heating capacity

Less than 24.36kW depends on whether to pass CCC compulsory certification Recently, the Florida Bureau of Quality Supervision organized and carried out the province’s heat pump water heater (heat pump) product

08/08/2020

How to deal with the noise of air-cooled heat pump unit

The scroll-type air-cooled heat pump unit adopts a noise control plan with a sound insulation cover installed to control its noise. The specific plan is as follows:

08/17/2020

What should I do if the compressor current of an industrial chiller is overloaded? okmarts.com editor has a coup!

The compressor current overload phenomenon of industrial chillers, cause analysis and solutions. The "overcurrent" here refers to the current overload of the chiller compressor.

08/13/2020

The way is right

Nowadays, cold storage has been widely used in the preservation of vegetables, fruits, fish and meat. But sometimes after use, there will inevitably be some aftertaste inside;

08/13/2020

Compressor in the industrial chiller system produces wet stroke fault and troubleshooting

In the industrial chiller system, when the compressor sucks in wet steam, frost occurs on the cylinder wall, and the suction temperature and discharge temperature drop significantly. This is the wet stroke of the compressor, commonly known as frost.

08/08/2020

Inspection method of refrigeration equipment in cold storage

Inspection method of refrigeration equipment in cold storage 1.Use the reverse operation of the system setting to evacuate the high-voltage system<br></br> 1. System principle and evacuation path

09/06/2020

Main properties of permanent magnet materials commonly used in motors

Permanent magnet materials commonly used in motors include sintered magnets and bonded magnets. The main types are AlNiCo, ferrite, samarium cobalt and neodymium iron boron.