Dimensions 32 x 74 x 60 mm are suitable for medium/low temperature forced air cooling systems with 2 evaporators traditional miniature temperature controller with four outputs: one compressor, one evaporator fan and two defrost (electric or hot gas), there can be up to four NTC or PTC probe inputs: one for the room temperature and two for the evaporator temperature (melting temperature). Frost end temperature + fan stop temperature control); the fourth probe input (can also be used by parameter selection), Connect to terminals 2 and 4 (either left or right) of the 5-pin hotkey programming key interface (requires connection device, must be ordered separately, model: NG6-K), which can be used to measure condensing temperature alarms or to display a certain point temperature; the hot key programming interface can be connected to the programming key, and can also be connected to the XJ485-CX communication conversion module Access to the network compatible with ModBUS-RTU protocol, such as DIXELL's XWEB series monitoring system. The parameters can be quickly copied through the keyboard setting on the panel or the programming key (HOT KEY).