There is no price at present, you can Request a Quote
50Phi Magnetic Incremental Encoder
Resolution:10 PPR
Output Method:NPN+PNP (Push-Pull)
Structure Strength:Standard type
Shaft Diameter:Hole Shaft 8.0 mm
Option:Cable leadwire
Starting Torque:30 gf-cm max
Shaft Moment of Inertial:8 g-square cm max.
Shaft Loading(Radial):2 kg max.
Shaft Loading(Axial):1 kg max.
Rotational Speed Max.:6000 RPM
Housing Material:Intensive PPS
Response Frequency:30K-120K Hz
FOTEK Encoder MET-10-H8
There is no price at present, you can Request a Quote
People who bought this item also viewed
Yaskawa Encoder SGMIH-3GA5D-NJX2
KOYO Encoder TRD-RV1024-4PR-T
MTL Encoder MEH-60-600P
Panasonic Servo Drive DV47L010MSGH
Customers frequently viewed
IWAYA DENKI Water Pump 25CJT0752
Panasonic Servo Motor MHMF022L1V2M
Honeywell Solenoid Valve VE4025B1045
ROTEN Mechanical Seal 8E5K-22-X
SANDSUN Overload Pump VA08H-760
GS Battery 6-QW-60(450)-(55D23L-KR)
Rechi Compressor 44R273A
MINDMAN Air Cylinder MCQV2-11-40-200
Mitsubishi Compressor YB645WTG
CKD Air Cylinder SSD2-L-25-10-T3YH-D
SHAKO Air Cylinder TC40B225
AirTAC Air Cylinder MAJ50X500-10S
Recent related posts
-
07/14/2020
Cold storage refrigerant leakage effect and detection method
Cold storage refrigerant leakage effect and detection method If the refrigerant leaks during the use of the cold storage, it will not only cause refrigerant waste, but also affect the refrigeration performance of the cold storage. Therefore, if there is leakage of refrigerant in the cold storage, it should be detected and repaired in time.
-
06/29/2022
4 Common Failure of Piston Pump
There are several common modes of failure for variable displacement piston pumps. Understanding these modes of failure, the causes, warning signs, and the prophylactic means of monitoring will help you to reduce unscheduled downtime.
-
08/11/2020
How to use central air-conditioning air-cooled water unit
One of the more prominent problems in the central air-conditioning water system is hydraulic imbalance. For some large-scale and more complex systems, there are usually many control loops.
-
07/02/2020
Five damage situations known to the compressor
Five damage situations known to the compressor Air conditioning has always been an indispensable "good companion" to accompany the hot summer! The reason the air conditioner can bring us cool is because of its internal compressor. If the air conditioner is used more and more frequently, then its internal compressor is prone to malfunction or even damage.
-
01/15/2021
dafoss low-pressure
Differential setting on low pressure control too low. Solution: Area Low pressure System Part Compressor Symptom Compressor running time too short Potential Cause Differential setting on low pressure contol too low. Solution Increase the differ 器2 䀀
-
09/04/2020
10 reasons why the compressor industry should participate in foreign exhibitions
I heard that there are some foreign exhibitions in the air compressor industry? Does it make sense to run so far to participate?
-
03/01/2021
Connection between Arduino and servo motor
The connection of the servo motor using Arduino is as follows: Connect the black wires on the two servo motors to the GND on the Arduino Connect the red wires on the two servo motors to the 5V pin on the Arduino Connect the yellow wire on the first motor to pin 8 on the Arduino
-
08/20/2020
Daily maintenance and maintenance methods of ground source heat pumps
At present, many office buildings and single-family villas have installed ground source heat pumps, but you should not think that you will have nothing to worry about after installation.
-
09/21/2020
Development Trend of Domestic Screw Refrigeration Compressor
Since the advent of screw compressors in 1934, after decades of technological improvement, screw compressors have been widely used, especially in refrigeration.
-
08/21/2020
Use cooling water circulation to avoid several problems
In the actual operation of the chiller system, there are often the following misoperations: 1. Failure to close the inlet valve of the condenser on the chiller that does not need to be opened before starting the machine, causing water leakage.