Fluid Inlet Size (in) 3/4
Fluid Inlet Thread Type NPT
Fluid Outlet Size (in) 3/8
Fluid Outlet Thread Type NPT
Manifold Configuration Center Port
Material Aluminum
Maximum Flow Rate (GPM) 8.5
Maximum Fluid Pressure (MPa) 0.8
Maximum Fluid Pressure (psi) 115
Maximum Operating Temperature (°F) 176
Minimum Operating Temperature (°F) 50
Power Source Air
Pump Ratio 1:1
Type Pneumatic Diaphragm Pump
GRACO Diaphragm Pump 233777
People who bought this item also viewed
GRACO Diaphragm Pump 233501
SEKO Diaphragm Pump MS1A094C
Ingersoll Rand Diaphragm Pump 66612B-244-C
Wilden Diaphragm Pump P400/PPPPP/WFS/WF/PWF
Becker Vacuum Pump DT4.10
Iwaki Magnet Pump MD-F401
STAIRS Water Pump SBK5-16/16
SIHI Mechanical Seal LPHC75340
Customers frequently viewed
IWAYA DENKI Water Pump 25CJT0752
Panasonic Servo Motor MHMF022L1V2M
Honeywell Solenoid Valve VE4025B1045
ROTEN Mechanical Seal 8E5K-22-X
SANDSUN Overload Pump VA08H-760
GS Battery 6-QW-60(450)-(55D23L-KR)
Rechi Compressor 44R273A
MINDMAN Air Cylinder MCQV2-11-40-200
Mitsubishi Compressor YB645WTG
Rockwell Allen-Bradley AB VFD 20G11NE052AA0NNNNN
KOGANEI Solenoid Valve 030-4E1-83-L
TPC Solenoid Valve DS3330-2DZ-02
Recent related posts
-
06/13/2020
Vane compressor
The vane compressor is directly driven at a very low speed. The rotor is the only continuously running component. There are a number of slots cut along the length direction, in which there are inserted vanes that can slide on the oil film. The rotor is in 器2 䀀 ᅵ皥 䖒
-
06/13/2020
The omni-directional strategy-fault and maintenance of piston refrigeration compressor
The omni-directional strategy-fault and maintenance of piston refrigeration compressor 1. The refrigeration compressor cannot start normally Maintenance ideas
-
06/13/2020
Carry out special inspection of centralized air conditioning and ventilation systems
Carry out special inspection of centralized air conditioning and ventilation systems Recently, the Keqiao District Sanitary Supervision Department has carried out special inspections
-
09/22/2023
Water-Cooled Chiller vs Air-Cooled Chiller: Which One is Better?
When it comes to cooling systems for large commercial buildings or industrial facilities, two of the most common options are water-cooled chillers and air-cooled chillers. Both types of chillers are designed to remove heat from a building or industrial process, but they operate in different ways and have their own unique advantages and disadvantages.
-
08/14/2020
The difference between independent and non-independent refrigeration units
The cold storage is a special place dedicated to refrigeration, and now it is mainly used to keep food fresh. With the increasing requirements for the freshness of food, the use of cold storage is gradually increasing.
-
05/10/2022
What is PLC?
Programmable logic controller (PLC) is a digital operation electronic system specially designed for application in industrial environment.
-
07/30/2020
What are the common faults of refrigerators?
Freezers are an indispensable piece of household appliances. After long-term use, more or less problems will occur.
-
06/30/2020
You should know the normal working condition of the compressor in the cold storage
You should know the normal working condition of the compressor in the cold storage 1. The suction temperature of the compressor should be 5-15℃ higher than the evaporation temperature.
-
01/06/2021
Summer baby blowing air-conditioning matters needing attention
Summer baby blowing air-conditioning matters needing attention Whether to turn on the air conditioner for children in summer has become a dilemma for mothers. not open? The child is uncomfortably hot; open? I'm afraid I'm not good for my baby. Tell me ho 器2 䀀 ᅵ皥 䖒皦즠Ʋ㎄ᰙ 㲈Ʋ 䌁皦 ᮔDž༬皧㎎ᰙЀ 呄ᠾ鹨់༹皧 ࠄ 00령ꐱ댁珵뛐珵Љ 䕄ྦ 뤂ᐱ뚜珵 ᴴᏩ呄ᠾ퍘ᒥ 鹨់ᩄ ꋔྦ 瑉浥 巠皱㙲皦抐皱 巠皱 ੨皦柘皱 ᅵ皥 ب 巠皱㙲皦忈皱 ੨皦柘皱 즠Ʋǜ 勁皦즠Ʋب ǜ V / 펔B䌁皦 ᮔDž '鱤džၜ먢䇨珵呈ᠾ뤂ᐱ ⿇⬿먲僧ᐱ㥲ᐲ�僬㣢ᐲ ᠾ 랖僧ب 識 �僬㣢ᐲ 臆S㥲ᐲ ᬄğ 識 理艏S杴 識杴 㥲ᐲ
-
08/19/2020
Knowledge of two air conditioners the same and different between evaporator and condenser
Condenser and evaporator are heat exchangers, which are widely used in refrigeration systems of high and low temperature alternating damp heat test chambers, constant temperature and humidity test chambers and other equipment.