IFM Sensor II5301

07/26/2020

Repair method of screw refrigeration compressor wear

The application of screw refrigeration compressors is becoming more and more common, and some of them have entered a period of frequent failures. When the abrasion of the female and male rotors, body, and exhaust end seat of the refrigeration compressor reaches above 0.65rnm, vibration will occur when the refrigeration compressor is running, the sound is abnormal, the cooling capacity is reduced, and the compressor cannot work normally.

06/29/2020

Compression ratio of American Copeland compressor

09/04/2020

Analysis of the advantages and disadvantages of 5 types of compressors

There are mainly 5 types of compressors, piston compressors, rolling rotor compressors, turbo compressors, screw compressors, and centrifugal compressors. This article briefly introduces the advantages and disadvantages of various compressors.

08/29/2020

Compressed air technology is moving towards an era of high efficiency

Compressed air is the most widely used energy source in industry and commerce, in addition to electricity. Its wide application stems from its easy operation, fast speed, high power density, safety and good compatibility, but its higher cost cannot be ignored...

08/24/2020

Poor cooling equipment There is a foreign body at work!

In the refrigeration system, the refrigerant contains various foreign substances such as moisture, non-condensable gas, refrigerating oil, metal shavings, grease, fiber, dust, etc.

08/25/2020

Renovation of the small turbine of the propylene refrigeration compressor oil station of the DCC unit has achieved initial results

Recently, the technicians of the DCC device have undergone transformation. The temperature of the small turbine bearing box of the propylene compressor oil station of the device has dropped from 90-120 degrees Celsius to 70-85 degrees Celsius

06/14/2020

The principle, installation and use of the bypass valve of the heater of the cold dryer Composition and principle of "heater bypass"

The principle, installation and use of the bypass valve of the heater of the cold dryer Composition and principle of "heater bypass" The energy regulation of the system is generally composed of the following ways: Compressor parallel-multi-stage contro器2䀀
ￜ皥
䖒皦즠Ʋ嫜ི㲈Ʋ
䌁皦
ᮔDž༬皧嫦ིЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ

09/10/2020

Advantages of air compressor equipped with permanent magnet synchronous motor

1. High efficiency The high efficiency mentioned here does not only mean that the efficiency of the rated power point is higher than that of the ordinary three-phase asynchronous frequency modulation motor, but refers to its average efficiency in the entire speed range. The excitation field of the permanent magnet synchronous motor is provided by the permanent magnet.

08/07/2020

How to improve the cooling efficiency of ground source heat pumps?

Generally speaking, if you want to improve the cooling efficiency of the ground source heat pump air conditioner itself, you need to consider many favorable factors before installation. To ensure the energy-saving operation of the unit, you can consider the following aspects.

06/14/2020

Brief introduction of magnetic suspension refrigeration compressor technology

Magnetic bearing is a high-tech product. Due to its high price, it was only used in aerospace engineering in the past. In 1993, Australia Multistack established a TURBOCORRD department, specializing in the application of magnetic bearings in refrigerationﰸ2䀀
ￜ皥
䖒皦즠Ʋ娼ི㲈Ʋ
䌁皦隆
ᮔDž༬皧婆ིЀ呄ᠾ鹨់༹皧
ࠄ
00븹먱댁珵理뛐珵Љ
䕄ྦ￿￿뤂ᐱ變뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់變ᩄꋔྦ
瑉浥巠皱㙲皦抐皱巠皱੨皦柘皱ￜ皥
ب巠皱㙲皦忈皱੨皦柘皱
즠Ʋǜ勁皦즠ƲبǜV