JOHNSON Electric Motor 70011

08/07/2020

Common physical and chemical methods for removing scale in condensers in chillers

The water chiller is prone to scale formation in the condenser pipe after long-term use. If it is not treated in time, these scales will affect the heat exchange effect and cause the condensing temperature of the unit to increase

09/22/2020

Compressed air drying and purification system composition

Since compressed air inevitably contains impurities such as solids, liquids, and gases, and each has its own characteristics, it cannot be achieved with a single device. Therefore, compressed air drying and purification becomes a system, a complete compressed air The drying purification system includes: 1) gas-liquid separator; 2) filter; 3) drying equipment and other facilities.

09/10/2020

Application of screw air compressor in power industry

Electricity is one of the most important energy sources in a country, and it is also the lifeblood of national economic construction and daily life. No matter what form of power generation is used, compressed air is inseparable in the power station.

02/10/2022

7 Reasons Why an Air Compressor is Overheating

As hot summer is coming, air compressor maintenance workers will also usher in the busiest season of the year.

08/12/2020

Master the following skills to make brazing easier

Brazing is a type of brazing. When the melting point of the flux is high, it is called brazing, such as brazing; there are three types of brazing, and the other two are not explained! Brazing is a good method for high-strength, leak-free connection

06/29/2020

How the compressor works

07/31/2020

What kind of equipment is suitable for high and low pressure refrigerant charging method

There are generally two types of refrigerant charging methods: low-pressure charging and high-pressure charging. The advantage of the low pressure charging method is that it is easier to control the amount of refrigerant charged,

07/18/2024

How to Tell if a Sprinkler Valve Solenoid Is Bad

Maintaining a lush, green lawn requires a properly functioning sprinkler system, and at the heart of this system are the valves.

08/16/2020

Why is the temperature too low after the cold storage is installed

After the cold storage is built, the first thing should be tested, so that we can know whether there will be problems after the cold storage is installed. Such a problem needs to be considered in the initial stage of the general cold storage installation.

08/24/2020

Causes of uneven liquid distribution in refrigeration systems and tragic cases!

If the distribution head is not evenly distributed, it will cause too much refrigerant in some of the branches, which will cause the evaporator to frost.