M-SYSTEM Transmitter M2VS-AA-M2/UL
People who bought this item also viewed
Meas Transmitter U5131-000005-100PA
M-SYSTEM Transmitter M5RS-3A-R
Danfoss Transmitter 061B100666
Adli Transmitter 4008.169.001
Trafag Transmitter 8472.77.5717
Danfoss Transmitter 060G1613
GF SIGNET Conductivity Meter 3-2821
FLUKE Pressure Gauge 730G27CN 2M
TAIE Temperature Controller FU400-101000
Customers frequently viewed
IWAYA DENKI Water Pump 25CJT0752
Panasonic Servo Motor MHMF022L1V2M
Honeywell Solenoid Valve VE4025B1045
ROTEN Mechanical Seal 8E5K-22-X
SANDSUN Overload Pump VA08H-760
GS Battery 6-QW-60(450)-(55D23L-KR)
Rechi Compressor 44R273A
MINDMAN Air Cylinder MCQV2-11-40-200
Mitsubishi Compressor YB645WTG
Recent related posts
-
09/05/2020
Top 10 tortures of frequency converters
There are ten major "tortures" of inverters today, which can also make your inverter suffer. Let's follow the editor of okmarts.com to explore the top ten "tortures" that will make your inverter "death than life"!
-
06/14/2020
Refrigeration compressors have five major technological
Refrigeration compressors have five major technological developments around energy saving CFCs and HCFCs refrigerants that have a destructive effect on the ozone layer are phase-out substances specified in the Montreal Protocol
-
09/14/2020
What is the difference between oil and oil-free air compressors
The oil and non-oil in the air compressor generally refer to the oil content of the exhaust gas of the air compressor. Generally, the oil content of the oil machine is larger, and the oil content of the oil-free machine is 0.01ppm,
-
08/16/2020
What parameters should be understood when choosing a central air-conditioning air-cooled heat pump unit
You must be familiar with central air-conditioning, but did you know that there is a unit in central air-conditioning called a cold and heat pump unit? The work of central air-conditioning is inseparable from it.
-
09/08/2020
Air compressor lubricant model the difference between No. 32 and No. 46 air compressor lubricants
Air compressor lubricants are generally No. 32 oil and No. 46 oil. No. 32 is a mineral type. The general service life is about 2000 hours and needs to be replaced. The operating temperature must be below 90 degrees to avoid carbon deposits.
-
08/13/2020
Have you figured out the "enthalpy" and "entropy" of the refrigeration system?
1. Enthalpy<br></br> It is a kind of energy, used to indicate the thermal state parameter of the state of the refrigerant, it represents the size of the total energy of the refrigerant; namely:
-
07/23/2020
FAQs about refrigeration compressors, do you know these?
Why control the impurity content and moisture content of the compressor and air conditioning system? Impurities entering the friction surface of the moving parts in the compressor pump body will cause abnormal scratches and wear. Impurities entering the solenoid valve, expansion valve, control valve, capillary tube and stop valve in the refrigerator system will block the valve hole or make the valve close tightly. And fail.
-
01/31/2023
What is a Gear Reducer?
The gear reducer is an independent enclosed transmission gear between the prime mover and the machine, which is used to reduce the speed and increase the torque to meet the work needs.
-
06/14/2020
What is the effect of pressure and temperature on the refrigeration system
What is the effect of pressure and temperature on the refrigeration system Refrigeration system performance testing involves many aspects, of which pressure and temperature are two points that cannot be bypassed. Today we will take a look at the pressure 器2 䀀 ᅵ皥 䖒皦즠Ʋ嫜ི 㲈Ʋ 䌁皦
-
06/21/2020
[Experience] What happens if the compressor suction pressure is too high and the discharge pressure is too high
[Experience] What happens if the compressor suction pressure is too high and the discharge pressure is too high Compressor suction pressure is too high, discharge pressure is too high 1. Too much refrigerant. Too much refrigerant will cause the suction pressure and discharge pressure to be too high at the same time. This is because when too much refrigerant fills the reservoir, it will occupy a part of the condenser volume, reducing the heat dissipation area and causing the condenser Poor condensation. Discharge excess refrigerant from the low-pressure side.