Mitsubishi Compressor SEB220FABMT

06/14/2020

Analysis and solution of the three reasons for the high temperature of the exhaust of the compressor dryer

Analysis and solution of the three reasons for the high temperature of the exhaust of the compressor dryer

07/05/2022

8 Common Concerns about Magnet Pumps

Magnet pumps are very different from typical sealed pumps. Therefore, it is natural for people to have concerns. I narrowed the list to 8 questions that are commonly asked with regard to mag-drive pumps.

06/23/2020

What is the reason why the freezer is not cooling

It may be that the capillary is blocked and the refrigerant flow does not enter the evaporator. It may also be that the refrigerant needs to be replenished or the refrigeration system is leaking. If the buffer tube inside the compressor ruptures, there may be loose screws or it will cause no cooling. It is also possible that the expansion valve and the discharge valve are not adjusted properly, causing cold air to leak out. Need to check one by one, and then take the medicine.

06/29/2020

Compression ratio of American Copeland compressor

08/08/2020

How to deal with the noise of air-cooled heat pump unit

The scroll-type air-cooled heat pump unit adopts a noise control plan with a sound insulation cover installed to control its noise. The specific plan is as follows:

06/27/2025

VFD Basics - How VFD Controls the Motor Running?

When the main circuit of the VFD is connected with the power line, in order to control the motor, it is necessary to connect the surrounding control circuit to the relevant terminals

06/14/2020

How important is the installation environment of the refrigeration unit It is enough to do these 4 points!

How important is the installation environment of the refrigeration unit It is enough to do these 4 points! The refrigeration equipment (compressor unit) is installed in the machine room, and the surrounding environment should be maintained:

06/14/2020

Air-conditioning product structure changes, rotary compressor 1 HP 1.5 HP is still the dominant model

Statistics show that at present, in terms of product structure of rotary compressors, 1 horse and 1.5 horses are still the dominant models. During the cold year of 09-13, the two industries accounted for between 50-60% of the total; followed by 1 horse Thﰸ2䀀
ￜ皥
䖒皦즠Ʋ娼ི㲈Ʋ
䌁皦隆
ᮔDž༬皧婆ིЀ呄ᠾ鹨់༹皧
ࠄ
00븹먱댁珵理뛐珵Љ
䕄ྦ￿￿뤂ᐱ變뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់變ᩄ

07/18/2020

Process and cause of liquid shock in piston refrigeration compressor

1. Introduction The phenomenon that liquid refrigerant and/or lubricating oil damage the suction valve plate when the gas is sucked into the cylinder of the compressor, and it is produced when the piston is compressed when the piston is close to the top dead center and is not quickly discharged during the exhaust process after entering the cylinder.

08/21/2020

Use cooling water circulation to avoid several problems

In the actual operation of the chiller system, there are often the following misoperations: 　　1. Failure to close the inlet valve of the condenser on the chiller that does not need to be opened before starting the machine, causing water leakage.