Don’t worry about the November holiday, let’s take a look at the air conditioner relocation

Don’t worry about the November holiday, let’s take a look at the air conditioner relocation

Tomorrow the November holiday will officially begin, and many friends who are backed up have asked for leave in advance to go home. When I’m idle this holiday, I don’t have to toss and toss, such as cleaning, tidying up clothes, catching up with friends who are decorating, and maybe buying electricity from buyers. I don’t want to buy a new air conditioner. It’s a good idea to move the original air conditioner. select. But do you know about the relocation of air conditioners?

First of all, if the informal army moves the air conditioner, the relevant manufacturer will no longer guarantee the product. Secondly, if the informal maintenance personnel move the machine, it is likely to charge excessive fees and arbitrary charges due to many factors such as technology, and cannot guarantee the future of the air conditioner. Use, so here, the editor brings you seven things to pay attention to when moving an air conditioner. You can become an expert in three minutes. Whenever an air conditioner is moved, you must know it well and not be deceived by the informal army.

Don’t worry about the November holiday, let’s take a look at the air conditioner relocation

　　 1. Test machine:

　　 Test whether the various functions of the air conditioner work normally before moving.

　　 2. Recover refrigerant and remove indoor and outdoor connection lines

　　 It is best to mark both ends of the connecting wire, so that there is no possibility that the connecting wire may be connected incorrectly and cause malfunction during installation.

　　 Three, keep the connection pipe interface clean

Since the used air conditioner is generally dusty, when removing the connecting pipe interface nut, pay attention to the cleaning of the bell mouth and the joint to prevent dust and dirt from entering the pipeline to prevent the pipeline from being blocked when the machine is moved. . Before installing the docking interface, check again whether there is any dirt on the bell mouth and inside, and then cover the nut after removing it. If it happens to be raining, you should wrap the nozzle with a plastic bag when you disassemble the connecting pipe to prevent rainwater from entering and causing ice blockage.

　　4. When disassembling the indoor unit, prevent condensate from flowing into the circuit board

Because there is some condensed water in the indoor unit's drain pan and drain pipe, when the indoor unit is disassembled and moved, the end of the indoor unit with the circuit board should not be turned down or even turned over. Instead, the end with the circuit board should be used. It is slightly higher to allow the water to flow out from the other end, so as to prevent the condensate from being poured into the circuit board and prevent electrical failure when starting up.

　　 5. Check the bell mouth of the connecting pipe

The bell mouth on the connecting pipe has been squeezed for a long time, and some bell mouth roots have a deep circle of indentation. These bell mouths are very easy to break, break, and leak when starting up. Therefore, the bell mouth must be removed. Carry out a careful inspection after downloading, and the unqualified ones must be cut and re-expanded, so as to avoid hidden dangers.

　　6. ​​During the transportation and installation of the external machine, it cannot be turned over. The inclination angle is too large. Do not lift the machine by grasping the stop valve by hand.

　　 In addition, you should also pay attention to handling and handling when moving the machine, the disassembly and assembly procedures are scientific, the pipe drawing direction is reasonable, and the bending force is moderate.

　　 Seven. Pay attention to the following aspects when reinstalling:

　　 1. Whether the wiring terminals or other places with wiring are loose, to prevent sparking or other hidden dangers, whether the wires are aging, and if they are aging, they must be replaced;

　　2. Check the connecting pipe and whether there is fluorine leakage at the joints. If the machine has been used for a period of time, if there is fluorine leakage, there will generally be oil stains at the leakage point;

　　3. Measure the insulation resistance of the air conditioner to prevent leakage of the air conditioner;

　　4. Whether the drainage pipe is reasonable.