How to manage the temperature after the cold storage is built
After the cold storage is built, the temperature in the cold storage must be better adjusted. This content is actually very important, but the corresponding precautions should also be grasped in the process of adjusting the temperature of the cold storage.
After the cold storage is built, it is necessary to effectively avoid temperature fluctuations in the cold storage. During the construction of the vegetable cold storage, we should first ensure the temperature in the cold storage to a certain stable state, so as to avoid frequent large fluctuations in the temperature in the cold storage, and only in this way can the normal metabolism of vegetables be suppressed to a certain extent . If the temperature of the cold storage is not effectively adjusted after the cold storage is built, the respiration of the vegetables will increase, and the metabolic decomposition of the vegetables will be accelerated, and the storage quality of the vegetables will be greatly reduced.
After the cold storage is built, if the temperature of the cold storage frequently fluctuates greatly, it will also cause the vegetables to become corrupt. If the temperature fluctuations are relatively large or more frequent, it will also have a greater impact. Therefore, we Corresponding heat insulation must be done during the construction of the cold storage.
At the same time, after the cold storage is built, it must be defrosted in time, but in the process of each defrosting, Kuhua Refrigeration recommends that the defrosting time should not be too long, otherwise it may cause the temperature in the cold storage to rise.
After the cold storage is built, we must reduce the entry and exit of the warehouse during our daily use. If it is necessary to purchase or exit the warehouse, the speed must be increased.
In the process of finishing or packaging operations, the interior of the cold storage should also reduce the lighting as much as possible, which will ensure a certain degree of temperature in the cold storage and can also promote the preservation of the stored items.
During the cold storage period of vegetables, the temperature of the product itself will generally be higher than the temperature of the cold storage. This is because after the vegetables are picked, they will continue to release heat due to their metabolism, especially when they are packaged. It will be higher, so after the cold storage is built, we must pay special attention to this content.
If we find that the temperature of the stored items is much higher than the temperature of the cold storage, then we can appropriately lower the temperature of the cold storage by about 0.2 degrees, so that we can better store vegetables, but after the cold storage is built, we must It should be noted that the temperature of the cold storage cannot be lowered in the later stage, otherwise it will cause the vegetables to become corrupt.
During the storage process, we can use a mercury thermometer to measure the temperature directly in the vegetables, so as to help us more accurately understand the temperature of the vegetables, so as to avoid large differences between the temperature of the vegetables and the temperature of the cold storage. This is also a temperature management method after it can be built, I hope everyone must fully grasp it.

Related Info
The new era of dual-supply air-conditioning refrigeration, floor heating and heating trend has arrived Introduction to the knowledge of central air conditioning vents Basic principles of data center cooling and energy saving solutions Refrigerator refrigeration system leak detection How does the cooling, heating, and dehumidification mode switch freelyHow to manage the temperature after the cold storage is built
Subscribe to relevant news content?
Subscription
Unsubscription
Recent related posts
Customers frequently viewed
IWAYA DENKI Water Pump 25CJT0752
US$2307.69
Panasonic Servo Motor MHMF022L1V2M
US$653.85
Honeywell Solenoid Valve VE4025B1045
US$334.62
ROTEN Mechanical Seal 8E5K-22-X
US$384.62
ABB Controller Module GCD207B101
Contact Us
Festo Air Cylinder ADNGF-32-60-P-A
US$205.95
TIMKEN Bearing EE192150/192200
US$1768.46
SKF Bearing 7217 CD/HCP4A
US$355.30
TECO Servo Motor TSB13202B-3BTA
US$1346.15
Copeland Compressor ZPD61KCE-TF7-425
Contact Us
SICK Relay UE48-20S3D2
US$384.62
Copeland Compressor 6DMXR37ME-TSE-C49
Contact Us
Fanuc Encoder A860-2005-T301
US$673.08