Parker Solenoid Valve E321F3202

09/16/2020

Compression purpose and method of compressed air theory

The basic purpose of gas compression is to deliver gas at a pressure higher than the original pressure. The original pressure level may vary from a very low absolute pressure (a few thousandths of a kilogram) to several thousand kilograms;

09/07/2021

How to Test a Mass Flow Sensor?

The mass flow sensor, or air flow sensor is one of the important sensors of the electronic fuel injection engine.

01/15/2021

Covid-19Taking precautions to keep the business running.

Covid-19Taking precautions to keep the business running. As the world steps up to the challenge of controlling the Covid19 virus, we are maintaining an unwavering commitment for safety as colleagues everywhere are keeping our operations and business goin器2䀀
ￜ皥
䖒皦즠Ʋ奌ི㲈Ʋ
䌁皦
ᮔDž༬皧奖ིЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥

07/05/2020

Why is frost formed between the electronic expansion valve and the compressor

Why is frost formed between the electronic expansion valve and the compressor? A customer asked: The compressor is suddenly not cooling, and the electronic expansion valve is frosted to the compressor. Is there any relationship between the two before?

06/29/2020

Compression ratio of American Copeland compressor

09/04/2020

Do you know the classification of commonly used filters

The impurities contained in the compressed air of the pneumatic system are divided into four categories: solid dust, moisture, oil mist and odor. In order to meet the requirements of different industrial sectors on the quality of compressed air,

08/07/2020

What are the central air conditioning performance that users care about

For any brand of central air-conditioning equipment, as a user, there are actually three points:

01/29/2025

FANUC spindle drive repair fault treatment

FANUC spindle drive maintenance problems mainly appear as stalls, abnormal speeds, motor oscillations, jitter during processing, and main circuit overcurrent alarms. Compared with AC FANUC spindle drive maintenance problems, the primary manifestations are motor overvoltage, fuse blown, etc.

03/03/2021

Control mode of servo motor

Torque control: the torque control mode is to set the external output torque of the motor shaft through the input of external analog quantity or the assignment of direct address. For example, if 10V corresponds to 5nm, when the external analog quantity is set to 5V, the output of the motor shaft is 2.5nm: if the load of the motor shaft is lower than 2.5nm, the motor will rotate forward, and when the external load is equal to 2.5nm

09/10/2020

In the next two years, the world's bearing demand will reach 76 billion US dollars

According to the forecast analysis report of the global bearing market by the industry research company, the global demand for ball bearings, roller bearings and sliding bearings is expected to grow at an annual rate of 8.5%, reaching 76 billion US dollars by 2014, of which unloading The largest demand for ball bearings and roller bearings.