Core Features Compact AC-DC Single-Output Design for 10V DC Loads: Functions as a space-saving industrial-grade power supply that converts 230V AC input to stable 10V DC output—optimized for powering low-voltage sensitive devices like precision sensors, micro-controllers, or small data loggers. It delivers 1A rated output current (10W power rating) with ultra-low output ripple (<30mVpp), ensuring clean, uninterrupted power for equipment that cannot tolerate voltage fluctuations or noise. High Efficiency & Low Energy Consumption: Equipped with switch-mode technology to achieve ≥82% efficiency (at full load), reducing energy waste and heat generation compared to traditional linear power supplies. The low no-load power consumption (<0.4W) further minimizes standby energy use, aligning with global industrial energy efficiency standards (e.g., EN 61000-3-2) for low-power equipment. Targeted Protection for Sensitive Gear: Integrates essential protection mechanisms to safeguard both the power supply and connected low-voltage devices: Overload protection: Limits output current to ~1.5x rated value to prevent damage during temporary load surges (e.g., sensor warm-up). Short-circuit protection: Shuts down output temporarily in case of short circuits, with automatic recovery once the fault is resolved—avoiding permanent damage to delicate electronics. Overvoltage protection: Clamps output voltage to ≤12V DC to shield 10V DC devices (e.g., micro-sensors) from voltage spikes common in industrial grids. Wide Input Tolerance & Industrial Durability: Designed to perform reliably in harsh industrial settings. It supports a wide input voltage range (100–240V AC), adapting to unstable grid voltages or global power standards (110V/230V AC). The operating temperature range of -20°C to +60°C allows deployment in cold warehouses or warm production floors, while an IP20 protection rating (IEC 60529) shields internal components from dust and accidental contact. Ultra-Slim Form Factor & Easy Installation: Features an ultra-compact, DIN-rail mountable design (35mm standard DIN rail) with a width of only 22.5mm—ideal for crowded control cabinets where space is limited. Tool-free terminal blocks enable quick, secure wiring (accepts 0.5–2.5mm² cables), and a bright LED status indicator (green for normal operation, red for faults) allows instant visual monitoring—reducing installation time and simplifying troubleshooting for low-voltage systems. Typical Applications The Phoenix Contact CM-62-PS-230AC-10DC-1-2942030 is engineered for stable 10V DC power delivery to low-voltage industrial devices—ideal for scenarios where sensitive equipment needs noise-free, consistent power in space-constrained setups—with core use cases including: Precision Sensor Power: Supplies 10V DC to low-voltage precision sensors (e.g., pressure transducers, flow meters, tiny temperature sensors) in process control systems. The ultra-low ripple eliminates signal interference, ensuring accurate measurement data—complying with IEC 61298-2 standards for process measurement instruments. Micro-Controller & Data Logger Power: Powers 10V DC micro-controllers (e.g., Arduino-based industrial modules) or small data loggers in monitoring systems (e.g., environmental sensing, asset tracking). The wide input tolerance handles grid fluctuations, while low standby power aligns with battery-backed or energy-efficient setups—complying with IEEE 802.15.4 standards for low-power IoT devices. Industrial Test & Measurement Equipment: Serves as a dedicated power source for 10V DC test instruments (e.g., small multimeters, signal generators) in factory quality control stations. The stable output ensures consistent test results, and the compact size fits in portable test kits—complying with IEC 61010-1 standards for electrical test equipment. Medical & Lab Auxiliary Power: Provides 10V DC to auxiliary components in low-power medical devices (e.g., patient monitor sensors) or laboratory equipment (e.g., mini centrifuges). The low noise and stable voltage meet sensitive device requirements, while the IP20 rating aligns with clean lab environments—complying with IEC 60601-1 standards for medical electrical equipment.