Rechner Sensor LEAK-500-P-O-PTFECapacitive sensors series leak

03/11/2021

The main circuit fuse fusing is a common fault of SCR servo driver. The causes of fuse fusing are as follows

The "phase sequence" of power incoming line is incorrect. Due to the synchronization problem between the trigger pulse and the main circuit of SCR servo driver, there are strict requirements on the "phase sequence" of the input power supply. If the "phase sequence" is not correct, connecting the power supply may immediately cause the fuse of the main circuit of the driver to blow.

06/29/2020

How the compressor works

09/01/2020

The most complete version｜Basic theoretical knowledge of compressed air (2)

Six, compression and compression ratio 　　1, compression 　　 Adiabatic compression is a compression process in which gas heat is not significantly transferred or transferred during the compression process.

09/05/2020

Talking about Lubricant and Air Compressor

At present, the mainstream product on the air compressor market is the screw air compressor. Screw air compressor gradually replaces piston air compressor with its product characteristics.

06/14/2020

Newly installed air conditioner, it trips when plugged in, what's going on

Newly installed air conditioner, it trips when plugged in, what's going on This question is about the problems that occur when the newly purchased appliances are used for the first time.

01/31/2025

Which Way Do Computer Fans Blow: 3 Seconds to Distinguish the Air Inlet and Outlet

The chassis fan is one of the very important accessories in the computer. It can effectively cool down the temperature, help the computer to dissipate heat and improve the stability of the entire system.

03/08/2023

The Differences of Double Acting Cylinder and Single Acting Cylinder

the single acting cylinder acts on one end of the piston, while the double acting cylinder acts as one end of the piston.

06/14/2020

The common oil shortage failures of scroll refrigeration compressors are here

The compressor has been short of oil for a long time-the mechanism and the friction pairs are overheated, resulting in bearing sintering and shaft holding. The compressor is short of oil for a short time-the mechanism and the friction pairs are abnorma器2䀀
ￜ皥
䖒皦즠Ʋ焬क़㲈Ʋ
䌁皦

07/16/2020

Limitations of motor protectors

The main purpose of motor protection is to protect the motor from burning, and the function of the protector is very limited, which is obviously an impossible task. In practical applications, there are many reasons that can cause the motor to burn down, which can be roughly divided into the following categories: motor overload caused by various

09/21/2020

GQYF-2A type air compressor comprehensive protection device

The six-channel temperature of the compressor is over-temperature, oil-cut, water-cut, and over-air pressure. Coal safety regulations have clearly required that the pressure fan equipment must be installed: