ROHM IC Integrated Circuit BA5930FP

09/09/2020

Various common problems of screw air compressor maintenance

1.What are the maintenance methods for screw air compressor motors? The operating environment of the motor should always be kept dry, the surface should be kept clean, and the air inlet should not accumulate dust, fibers and other debris.

07/22/2020

The working principle of cooling and heating of air conditioning

In addition to the cooling function, the heating and cooling air conditioner also has the heating function. The biggest difference from a single-cooling air conditioner is that an electromagnetic four-way reversing valve is installed in the heating and cooling air conditioner.

08/02/2020

Basic principles of data center cooling and energy saving solutions

Basic principles of data center cooling and energy saving solutions<br></br> Each data center has its own characteristics, so there is no technical solution that can be applied to any data center.

08/24/2020

Six questions about air conditioning This is what novices really need!

1. Even though the heat pump air conditioner has automatic defrosting, why the heating effect below -5℃ is not good?

06/29/2020

How the compressor works

09/09/2020

The influence of machining on fatigue life

The residual compressive stress introduced by shot blasting/shot peening is a percentage of the final tensile stress strength, and this ratio increases as the strength/hardness of the part material itself increases. High-strength/hardness metals are more brittle and more sensitive to surface defects. Shot blasting/shot peening will allow these high-strength metals to be used in fatigue-prone working conditions. Aircraft landing gear is usually designed with a fatigue strength of 300 ksi (2068 MPa), combined with shot blasting/shot peening.

07/27/2020

Do you know the reasons for the attenuation of the cooling capacity of the screw refrigeration unit?

Lithium bromide absorption refrigeration units are a type of refrigeration equipment that will inevitably produce cold capacity attenuation.

08/09/2020

DORIN compressor

DORIN Compressor Co., Ltd. of Italy was established in 1918. It is one of the founding organizations of ASERCOM in Europe and one of the few top refrigeration compressor manufacturers in the world.

06/14/2020

What's going on with frost during refrigeration compressor operation

Whether the compressor will frost depends on the evaporation temperature of the system and the superheat of the return air. The dry storage evaporator system of cold storage and refrigerator freezer, the refrigeration system under standard working conditi器2䀀
ￜ皥
䖒皦즠Ʋ煔क़㲈Ʋ
䌁皦
ᮔDž༬皧煞क़Ѐ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥巠皱㙲皦抐皱巠皱੨皦柘皱ￜ皥
ب巠

06/29/2020

Introduction of measures for compressor pressure protection

Introduction of measures for compressor pressure protection Measures for compressor pressure protection include the following: 1. Control of suction and exhaust pressure When the compressor is running, due to the system or the compressor itself, the discharge pressure may be too high or the suction pressure may be too low. For this reason, the suction and discharge pressures need to be controlled.