MS40 - 7043 - 501 1.Part Number：MS40-7043-501 2.Power Input：24 Vac ± 20%, 22 - 30 Vdc；Running: 5.6 VA, 4.2 W；Holding: 0.15 W；Max. Stall: <130 3.Control Signal：2 - 10 Vdc (input impedance 80 k ohms) or 4 - 20 mA with 500 ohm (input impedance 500 ohms) 4.Output Torque Rating：150 lb.-in. (17 N-m) 5.Electrical Outputs 1.Position Feedback Voltage “AO”：2…10 Vdc (max. 0.5 mA) output signal for position feedback or to operate up to four additional slave actuators 2.Auxiliary Switches：One SPDT 6A (1.5A) @ 24 Vac, adjustable 0° to 95° rotation (0 to 1 scale) 6.Mechanical Outputs 1.Stroke：Angle of rotation 95° ±5°. Adjustable 40°…95° by adjusting the stop block position on the actuator 2.Damper Shaft Clamp：The factory installed universal clamp is used for shafts up to 5/8” (15 mm) diameter or up to 1/2” (13 mm) square. AM-710 accessory clamp is required when mounting actuators to shafts up to 3/4” (19 mm) diameter or up to 1/2” (13 mm) square 3.Position Indicator：Visual indicator, 0 to 1 (0 is spring return position) 7.Environment 1.Ambient Temperature Limits：Shipping & Storage: -40…160°F (-40…71°C); Operating: -22…140°F (-30…60°C) 2.Humidity：15…95% RH, non-condensing 3.Location：NEMA 2 (IEC IP54) no restrictions 8.Agency Listings 1.UL 873：Underwriters Laboratories (File #E9429 Category Temperature-Indicating and Regulating Equipment) 2.CUL：UL Listed for use in Canada by Underwriters Laboratories. Canadian Standards C22.2 No. 24-93 3.European Community：EMC Directive (89/336/EEC). Low Voltage Directive (72/23/EEC) 4.Australia：This product meets requirements to bear the RCM Mark according to the terms specified by the Communications Authority under the Radiocommunications Act 1992 9.Accessories：Refer to the accessory list in the document, such as AM-708 500 W resistor for 0…20 mA control signal may be relevant for control signal conversion in some cases