Schneider Circuit Breaker OSMC32N4C32KG

07/22/2022

How to Prime a Water Pump

Water pumps will run out of pressure and stop working if turned off for an extended period of time, such as over the winter.

09/05/2020

The problem of motor inefficiency

The test standards promulgated by the International Electrotechnical Commission IEC (hereinafter referred to as IEC) make it possible to evaluate the energy efficiency of motors.

03/03/2021

Control mode of servo motor

Torque control: the torque control mode is to set the external output torque of the motor shaft through the input of external analog quantity or the assignment of direct address. For example, if 10V corresponds to 5nm, when the external analog quantity is set to 5V, the output of the motor shaft is 2.5nm: if the load of the motor shaft is lower than 2.5nm, the motor will rotate forward, and when the external load is equal to 2.5nm

07/29/2025

What is Hydraulic Pump? (Function, Types, Application＆Selection Method)

The basic hydraulic system components include oil tank, hydraulic pump, control valve, oil cylinder, connecting pipe and relief valve.

09/07/2020

The most complete air compressor energy saving transformation method

Due to the design standard of the air compressor, the user can only determine the motor capacity according to the maximum demand when selecting the model, resulting in a large margin in the air compressor system.

09/14/2020

Intake valve cannot open fault

Quanzhou failure analysis In Quanzhou in the past two days, I was debugging an air compressor. I encountered such a problem. The unit was operating normally for the first time. However, after shutting down and turning on, the unit was abnormal and could not pump air. At present, it can be guaranteed that the original electrical appliances are normal.

06/14/2020

Refrigeration compressor failure phenomenon and determination method

Refrigeration compressor failure phenomenon and determination method 1. How to identify the three binding posts on the casing of the hermetic compressor? Running end (R), starting end (S), common end (C), the resistance between RS is greater than that器2䀀
ￜ皥
䖒皦즠Ʋ嫜ི㲈Ʋ
䌁皦
ᮔDž༬皧嫦ིЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥巠皱㙲皦抐皱巠皱੨皦柘皱ￜ皥
ب巠皱㙲皦忈皱੨皦柘皱
즠Ʋǜ勁皦즠ƲبǜV /펔B䌁皦
ᮔDž'鱤džၜ먢䇨珵呈ᠾ뤂ᐱ⿇

08/13/2020

Reasons for vibration of inlet and outlet pipes of reciprocating compressor

During the air load test of the carbon dioxide compressor, the pipeline between the third-stage outlet buffer and the third-stage cooler, the pipeline between the fourth-stage outlet buffer and the fourth-stage cooler,

06/14/2020

15 common sense of refrigeration and air conditioning!

1. The air conditioner cannot be restarted immediately after it is turned off After the central air conditioner is shut down, it can only be operated after 3 minutes. This is because the timing protector will automatically work to prevent the compresso器2䀀
ￜ皥
䖒皦즠Ʋ煔क़㲈Ʋ
䌁皦
ᮔDž༬皧煞क़Ѐ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿

06/29/2020

Several causes of compressor burning