Schneider Relay LT3SA00M

06/14/2020

Is PVC or PE good for domestic fresh air system pipes

Is PVC or PE good for domestic fresh air system pipes Fresh air system is a category of light equipment and heavy design. Fresh air equipment is highly dependent on design and construction.

07/20/2020

Six aspects of repair and maintenance of refrigeration compressors in cold storage

A. During the initial operation of the cold storage unit, carefully observe the oil return of the compressor and keep it clean. If you find that the oil level is not clean enough or if the oil level drops, you should add oil or replace it with new oil in time. This can avoid poor lubrication

06/23/2022

How to Test a Transformer?

Transformers are an electrical component that transmit electrical energy between at least two circuits. Transformers regulate the voltage in circuits, but in some cases these can go bad and cause a circuit to not work.

06/14/2020

Danfoss cocuses on providing energy efficient, sustainable and smart refrigeration compressors for a varied range of commercial applications such as cold rooms

08/11/2020

What role does the air conditioning and refrigeration cabinet in the computer room play

What role does the computer room air-conditioning and refrigeration cabinet play? The hot aisle/cold aisle cabinet layout method is adopted by modern data centers and is also recognized as the best layout method for data centers.

08/08/2020

How to deal with the noise of air-cooled heat pump unit

The scroll-type air-cooled heat pump unit adopts a noise control plan with a sound insulation cover installed to control its noise. The specific plan is as follows:

06/14/2020

Characteristics of fin heat exchanger

Characteristics of fin heat exchanger The heat transfer efficiency is high. The disturbance of the fins to the fluid causes the boundary layer to continuously rupture, which has a large heat transfer coefficient. At the same time, because the separator a器2䀀
ￜ皥
䖒皦즠Ʋ娼ི㲈Ʋ
䌁皦
ᮔDž༬皧婆ིЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥

09/08/2020

Introduction of micro heat regeneration adsorption dryer

The non-thermal regeneration suction dryer uses the compressed air pressure change, adsorption under high moisture pressure, and desorption under low moisture pressure to regenerate the adsorbent.

09/08/2020

What are the application areas of air compressors

In which industries are air compressors popular? As a general-purpose equipment in the new era, air compressors are inseparable from any gas demand. Below, let's take a look at the application areas of air compressors!

08/17/2020

What should I do if the compressor current of an industrial chiller is overloaded? okmarts.com editor has a coup!

The compressor current overload phenomenon of industrial chillers, cause analysis and solutions. The "overcurrent" here refers to the current overload of the chiller compressor.