DIN Rail or Screw Mounted Protective Relays
WD25 Paralleling (Synch Check) Relays
Power Consumption: 2.5VA, maximum
TYCO Relay WD25-013
People who bought this item also viewed
JEL Relay S1C-225WDV
SIEMENS Relay 3TK2824-1AL20
Riken Relay RAB-150N
Schneider Transformer ABT7PDU025B
Siemens Contactor 3RT2535-1AP00
DEHN Surge Protection Device DR M 4P 255
Littelfuse Fuse 0805L010YR
Customers frequently viewed
IWAYA DENKI Water Pump 25CJT0752
Panasonic Servo Motor MHMF022L1V2M
Honeywell Solenoid Valve VE4025B1045
ROTEN Mechanical Seal 8E5K-22-X
SANDSUN Overload Pump VA08H-760
GS Battery 6-QW-60(450)-(55D23L-KR)
Rechi Compressor 44R273A
MINDMAN Air Cylinder MCQV2-11-40-200
Mitsubishi Compressor YB645WTG
Eaton Vickers Vane Pump 3520V-38A8-1BB22R
CKD Air Cylinder SSD2-L-16-30-N-W1
Festo Air Cylinder DGSL-16-100-PA
Recent related posts
-
08/15/2020
How to operate the cold storage distribution box during cold storage installation
In the process of cold storage installation, the use of cold storage power distribution boxes is a very important content, but most people are not very familiar with the normal operation of cold storage power distribution boxes.
-
09/10/2020
Lubrication characteristics and requirements of mobile air compressors
1. The characteristics of the mobile air compressor are: (1) The mobile air compressor should be easy to move frequently, the working conditions are changeable, and the load changes greatly. (2) Mobile air compressors are mostly heavy-duty, medium-speed or low-speed transmission, and most require frequent starting and often withstand shock loads;
-
07/20/2020
How to judge the starter of the refrigerator compressor is broken
1. The heavy hammer starter, the part that is easily damaged is the poor contact of the start contact. During the measurement, the weight starter can be removed and measured with a multimeter ohm block according to the original installation direction.
-
03/12/2021
Working principle of servo drive
At present, most servo drivers use digital signal processor (DSP) as the control core, which can achieve more complex control algorithm, digitalization, networking and intellectualization. The drive circuit based on intelligent power module (IPM) is widely used in power devices.
-
03/07/2021
AC servo driver wiring precautions
For signal line and encoder input line, please use shielded wire. Wiring length: the length of signal line from NC to AC servo driver is less than 3m, and the length of input line from AC driver to encoder is less than 20m. The ground wire should be thick wire as far as possible. According to the third grounding standard (grounding resistance < 100 Ω), one point grounding method should be adopted to connect the ground wire. If the motor and the machine tool are insulated, the motor should be grounded.
-
04/25/2023
What are the 4 Main Components in a Central AC System
There are four main components in the central air conditioning system, namely: compressor, condenser, throttling device, and evaporator. Evaporators and condensers are collectively referred to as heat exchangers
-
08/15/2022
Top 10 Brands of Linear Motors
There are many brands of linear motors in the world. The following are some well-known brands of linear motors from countries and regions like Europe, America, Japan, Asia, etc. Hope it will be helpful to you.
-
06/13/2020
11 common protection devices for refrigeration compressors
11 common protection devices for refrigeration compressors When the compressor is running, some abnormal conditions may occur, such as: the discharge pressure is too high
-
09/12/2022
Differences between a Sensor and an Actuator
A sensor is a detection device that can sense the measured information, and can transform the sensed information into electrical signals or other required forms of information output according to certain rules to meet the requirements of information transmission
-
06/26/2020
Maintenance method of refrigerator compressor without stopping
Maintenance method of refrigerator compressor without stopping The focus of non-stop compressor maintenance is on the cooling effect. If the cooling effect is normal without stopping, the fault is in the thermostat. Otherwise, it is because the system lacks fluorine and the temperature falls below the control point, which results in non-stop. When repairing,