Avesta Welding Wire 904L

06/14/2020

What is the difference between heating 24 ℃ and cooling 24 ℃

Regardless of the room temperature, as long as the air conditioner is in the cooling mode and is in a working state, the wind blown out is cold wind. To put it bluntly, the temperature of the blown air is determined by the operation mode of the air condit器2䀀
ￜ皥
䖒皦즠Ʋ煔क़㲈Ʋ
䌁皦
ᮔDž༬皧煞क़Ѐ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥

07/27/2020

Do you know the reasons for the attenuation of the cooling capacity of the screw refrigeration unit?

Lithium bromide absorption refrigeration units are a type of refrigeration equipment that will inevitably produce cold capacity attenuation.

08/11/2020

Instructions for the use of ultra-low temperature storage boxes and daily care methods

Instructions for the use of ultra-low temperature storage boxes and daily care methods<br></br> 1. Transportation and storage matters<br></br> 1. When unloading from the truck, use a double forklift and pay full attention to safety.

03/18/2021

Parameter setting method of servo motor driver

The larger the setting value, the higher the gain and the greater the stiffness. Under the same frequency command pulse condition, the position lag will be smaller.

09/06/2020

What are the requirements of modern industry for oil-free air compressors

After the air is mechanically compressed, it becomes compressed air. The equipment used to produce compressed air is usually called an air compressor. Compressed air is an indispensable pneumatic energy source in people's production and life.

07/31/2020

Common problems and solutions of industrial chillers summarized by the maintenance master

1. Water leakage (first determine the location of the water leakage)<br></br> 　　 1. Water leakage from the pump (causes: the shaft seal at the water pump is not well connected or the shaft seal has been damaged)

06/29/2020

Suggestions for troubleshooting of compressor with liquid start

06/30/2020

Common faults and causes of compressors

Common faults and causes of compressors Common compressor failures are as follows: 　　L. The compressor cannot start normally 　　 The power supply voltage is too low, the motor circuit is poorly connected, or the exhaust valve is leaking, resulting in too high pressure in the crankcase. The energy regulation mechanism has failed.

07/01/2020

The stability of the typical performance of Taikang compressor

The stability of the typical performance of Taikang compressor Many people know the performance of Taikang compressors, but nothing more than the typical characteristics, such as pressure ratio, efficiency, mass flow and additional energy. But many people do not know that Taikang compressor has another more important feature, that is stability. Why is the stability of Taikang compressor so important?

01/04/2022

Application of Servo System in Textile Machinery

As the product of the development of modern science and technology, servo system with its irreplaceable role and excellent performance, can be found in almost every area of industry.