Beckhoff Module EL9576

08/18/2020

Several issues that need attention in the cold storage verification report in the new GSP requirements

The new version of the GSP requires that pharmaceutical business and distribution companies must build a temperature and humidity monitoring system, and form a verification report after scientific testing for inspection by the drug regulatory department.

03/02/2021

Information about ABB motor

ABB motor is a kind of electromagnetic device which realizes the conversion or transfer of electric energy according to the law of electromagnetic induction ABB servo motor is installed as follows:

06/29/2020

Several causes of compressor burning

12/08/2023

Air Cooling and Liquid Cooling: Introduction to Data Center Cooling System Technology

Most of the electrical energy consumed during the operation of electronic information equipment in the data center is converted into waste heat.

09/23/2020

Application of DCS system in anti-surge control system of air separation compressor

Keywords: DCS system, air separation compressor, anti-surge control system Preface 　　 The 6000m3/h air separation plant of Xilin Iron and Steel Company was completed in May 2001 by Hangzhou Oxygen Concentrator Group Company. The factory design was designed by Beijing Iron and Steel Design Institute. It was successfully put into operation on September 2, 2001, and it took more than half a year to run. It shows that the unit is operating stably, and all indicators have reached or exceeded the design value. The entire control system uses Honeywell’s TDC3000 and two GUS stations.

05/01/2024

Common Faults and Solutions of Servo Drives

Servo drive is a commonly used motor control device, commonly used in various automated production equipment and robot control systems.

06/24/2020

What is the reason why the freezer is not cooling

It may be that the capillary is blocked and the refrigerant flow does not enter the evaporator. It may also be that the refrigerant needs to be replenished or the refrigeration system is leaking. If the buffer tube inside the compressor ruptures, there may be loose screws or it will cause no cooling. It is also possible that the expansion valve and the discharge valve are not adjusted properly, causing cold air to leak out. Need to check one by one, and then take the medicine.

08/04/2020

How to accurately choose the power cord of the refrigeration equipment

The installation of refrigeration equipment is a very rigorous work, and its installation situation will affect the work of the machine to a large extent.

12/17/2024

Projector Cooling: How to Effectively Cool Down a Projector

Friends who once used projectors will easily notice a phenomenon: when standing next to the projector, they will feel bursts of hot air. So friends, have you ever wondered why projectors heat up?

08/17/2020

Detailed knowledge of screw chiller system

How to improve the service life of screw chillers and reduce the failure rate of screw chillers? This problem has been plagued by many friends, and it is also a relevant knowledge module they want to know very much.