Description The DICON touch is a univeral process and program controller with 4 channels, which displays information on a vibrant display and is operated intuitively with touchscreen. Up to 4 control channels are available via the tried-and-tested JUMO control algotithm with two possible optimization variants. These enable a simple and highly-accurate startup. Even multiple-zone control, cascade control, or other complex control tasks are therefore possible. In the followting block diagram, the various hardware options tasks are therefore possible. In the following block diagram, the various hardware options can acquire a variety of physical measured values with high precision. Thanks to different output variants, the actuators can be controlled directly in the device, either in an analog manner or digitally. These can be expended further through external digital outputs. To communicate with higher-level systems, interfaces such as Modbus(master/slave), PROFIBUS, PROFINET-RT, or Ethernet with web serve, can be used. To ensure secure process operation, the device has password-protected user administration with individual assignment of rights for different levels or control commands, Screen masks for conreollers, program generators, recording, and for overview screens are ready-made and availabel.Four individual process screens can be created as desired using the configuration software. Important extra code,visualized graphically, and exported to PC in a tamper-proof manner via interface or USB flash drive The configuration software allows for the process controllers to be programmed with ease, for math and logic coherences to be descried, and for customer-specific linearizations to be created. Additonally, tools are included for simulating external siganls or the control process, or to record for the duration of the startup. A comprehensive alarm and limit value concept as well as flexibile digtial signal management complete the "all-in-one-device."