MICRON IC Integrated Circuit Chip PC48F4400P0VB0E3

08/19/2020

The development trend of air-conditioning condenser and evaporator

The condenser is the main heat exchange component in the air conditioner. The heat absorbed by the air conditioning system and the heat generated by the compressor work all rely on it to be dissipated into the outside air.

08/03/2020

Compressor exhaust overheating is not that complicated, just for these few reasons!

The main reasons for the exhaust temperature overheating are as follows:<br></br> 　　 High return air temperature, large heating capacity of the motor, high compression ratio, high condensation pressure, improper refrigerant selection

07/22/2020

Method for identifying failure of hermetic refrigeration compressor

The resistance between running terminal (R), starting terminal (S), common terminal (C), RS is greater than the resistance between SC and RC. The resistance between RS is equal to the resistance between SC and the resistance between RC.

08/02/2020

How to determine the refrigerant leakage of the air conditioning system Only need these six steps

Shut down and unplug the air conditioner (to prevent danger during the inspection process), and connect a pressure gauge to the large valve. Observe the static pressure.

08/14/2020

Cold storage management, maintenance, use and troubleshooting methods

Treasury management should set up a special team, pay special attention to waterproof, moisture, heat, cold running, and fluorine escape, and strictly control the five barriers of ice, frost, water, doors, and lights.

06/29/2020

Compression ratio of American Copeland compressor

01/12/2024

Defrosting of Cold Storage Air Coolers (with 9 Other Common Faults of Air Cooler and Their Troubleshooting Methods)

The air cooler for a cold room is also called a cold room evaporator, air cooled evaporator, unit cooler, refrigeration evaporator, etc.

06/14/2020

The specific operation method of screw refrigeration compressor maintenance

Before the screw compressor must be overhauled, if possible, unload the slide valve to the "0" position, shut down normally, and cut off the power supply. The pipeline connected to the compressor should be cut off and the refrigerant and lubricating oil i器2䀀
ￜ皥
䖒皦즠Ʋ煔क़㲈Ʋ
䌁皦
ᮔDž༬皧煞क़Ѐ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥巠皱㙲皦抐皱巠皱੨皦柘皱ￜ皥
ب巠皱㙲皦忈皱੨皦柘皱
즠Ʋǜ勁皦즠Ʋبǜ

08/20/2020

Several key selection points of screw chillers

How can it be used in combination to achieve the effect and use it at the lowest operating cost? Therefore, the selection has become a very critical part. In industrial production, mechanical equipment will generate heat during operation.

08/09/2020

Common oil shortage failures of scroll refrigeration compressors

The compressor is short of oil for a long time-the mechanism and the friction pairs are overheated, causing the bearings to sinter and hold the shaft.