Mitsubishi Module RM10TA-H

07/25/2020

How to distinguish the quality of the wire?

Good strong wires are the basic level of home circuit engineering, so how do consumers judge which strong wires are good wires?

06/29/2020

Suggestions for troubleshooting of compressor with liquid start

08/20/2020

What to do if there is a refrigerant leak in an industrial chiller

When an enterprise uses an industrial chiller, if there is a serious leakage of refrigerant, the equipment will inevitably stop operating. Because industrial chillers have complete safety early warning equipment

08/27/2020

When is the best time to change the bearing oil?

Under normal circumstances, it is very common to replace the lubricating oil in a short period of time, and more grease is often added. Let me explain to you the relevant knowledge below, I hope it will be helpful to you

09/02/2022

The Working Principle of the Vacuum Contactor

The vacuum contactor uses the vacuum interrupter to extinguish the arc to frequently connect and cut off the normal working current.

06/14/2020

What are the models of refrigeration compressors

What are the models of refrigeration compressors As we all know, there are refrigeration compressors in the refrigerators and air conditioners that we commonly use. The core of the air conditioner and refrigerator is it. Whenever it is, the air condition器2䀀
ￜ皥
䖒皦즠Ʋ煔क़㲈Ʋ
䌁皦
ᮔDž༬皧煞क़Ѐ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵ᴴᏩ呄ᠾ퍘ᒥ鹨់ᩄꋔྦ
瑉浥巠皱㙲皦抐皱巠皱੨皦柘皱

08/14/2020

Analysis of common problems in the design of refrigerant multi-connected air conditioning system

1. Applicable area and scope of refrigerant multi-connection system 　　 Refrigerant multi-connection system is suitable for areas: The refrigerant multi-connection is suitable for hot summer and cold winter areas, hot summer and warm winter areas, and some cold areas.

08/19/2022

What is Linear Motor and How Does It Work

electric motor is a device that converts electrical energy into mechanical energy

08/09/2020

Can you answer these common basic knowledge questions about refrigeration compressors?

1. Why should the compressor run continuously for at least 5 minutes, and stop for at least 3 minutes after shutting down before restarting?

06/29/2020

What are the causes treatment and prevention methods of compressor liquid blow

What are the causes, treatment and prevention methods of compressor liquid blow Liquid blow means that the refrigerant liquid or wet steam is sucked into the compressor by the compressor due to failure or insufficient absorption of heat, which is called liquid blow. First, the main reasons are as follows: