How to maintain the servo motor?

Regularly check the encoder connection line of the servo motor and the power connector of the servo motor to confirm that the connection is firm;

If the servo motor is connected to a reduction gear, an oil seal should be added when using the servo motor to prevent the oil from the reduction gear from entering the servo motor.

Regularly check the output shaft of the servo motor to ensure smooth rotation;

Regularly check whether the cooling fan of the servo motor is running normally;

Regularly check the servo motor to ensure that there is no fatal damage outside;

Regularly check the fixed parts of the servo motor to ensure that the connection is firm;

Although the servo motor has a high level of protection, it can be used in dusty, damp or oily places, but it does not mean that you can immerse it in water to work, you should try to keep it relatively clean environment.

Clean up the dust and oil on the servo motor in time to ensure that the servo motor is in a normal state.

Recent related posts

02/27/2021

How to maintain the servo motor?

How to maintain the servo motor 1. Regularly check the encoder connection line of the servo motor and the power connector of the servo motor to confirm that the connection is firm;

02/27/2021

Some common faults and solutions of servo motors

The temperature of the motor is too high or the motor is faulty with smoke the reason: 1). Excessive load 2). Two-phase operation

02/27/2021

Debugging method of servo motor

Before wiring, initialize the parameters. On the control card: select the control method; clear the PID parameters; let the default enable signal turn off when the control card is powered on; save this state to ensure that the control card is in this state when it is powered on again.

09/23/2020

Automatic control scheme for multiple adsorption dryers and air compressors

With the development of modern industry and the improvement of automation level, various industries have higher and higher requirements for air supply, purification level, automatic control, and continuous and reliable air supply of air compressor stations.

09/23/2020

Installation foundation of compressed air pipeline

Basic knowledge is very important for sheet spray work, and the same is true during equipment installation. When installing compressed air pipelines, everyone must pay attention to the following precautions:

09/23/2020

Delta PLC's application in screw air compressor

1. Design intent　　 For cost reasons, the control systems used in the air compressor manufacturing industry for a long time have been controlled by single-chip microcomputers, and digital tubes indicate working status and indicate parameter values

09/23/2020

Talking about screw compressor

It has become an inevitable trend to use highly reliable screw compressors to replace piston compressors with many wearing parts and poor reliability. Japan's screw compressors accounted for only 27% in 1976, and rose to 85% in 1985; the current market share of screw compressors in western developed countries is about 80%, and it maintains an upward trend.

09/23/2020

Air compressor classification, working principle and air compressor selection

Air compressor classification, working principle and air compressor selection The air compressor is the main body of the air source device. It is a device that converts the mechanical energy of the prime mover (usually an electric motor) into gas pressure energy, and is a pressure generating device for compressed air.

09/22/2020

Discussion on Technology Development of CNG Natural Gas Compressor

1 The rapid development of CNG As of 1999, there were nearly 70 CNG stations in 12 demonstration provinces and cities across the country, and the number of clean vehicles (NGV) was less than 10,000. After four years of rapid development, as of October 2003, there were 16 stations nationwide.

09/22/2020

Discussion on Calculation Method of Surge Line of Rich Gas Compressor

1 Introduction The catalytic cracking rich gas compressor is a kind of compressor, which is very representative. For this reason, the catalytic cracking rich gas compressor is taken as an example to discuss the calculation method of the surge line of the rich gas compressor control system.