Pay attention to keep the compressor lubricating oil clean Why should we pay attention to keeping the compressor lubricating oil clean? This is because the dirty oil of the compressor or the deteriorated lubricating oil will cause a vicious cycle of accelerating the wear of the parts. Therefore, we should clean the lubricant oil of the compressor according to the following requirements: Compressor Importantly replace and clean the filter element in the clogged oil filter for the forced circulation type lubrication system;
Second, the oil in the oil tank or oil sump should be prevented from being exposed to the air to prevent dust and dirt from mixing into the oil. For the pressureless oil tank and oil sump, an air filter can generally be used to communicate with the atmosphere; 3. During mid- and overhaul, samples should be taken from the oil to test its composition. If it meets or exceeds the oil change target, the new oil should be replaced or replaced in whole or in part. Fourth, usually every 3 months to half a year (or work 2000-4000h) can be replaced with new oil. Fifth, use ACC-GR bearing grease and mix with 6% ACC-ET, the oil change interval can be extended properly. VI. The extended time is related to the length of time that ACC products are used and the state of the equipment itself. 7. The quality of the oil can be tested after the prescribed oil change cycle. As long as we clean the compressor lubricating oil according to the requirements described above, generally speaking, it is unlikely that more serious failures or problems will occur. I hope the introduction in this article will be helpful to you!
