Precautions for the use of ultra-low temperature storage boxes
The ultra-low temperature storage box is shipped after more than 12 hours of debugging before leaving the factory. Today, the editor of the ultra-low temperature storage box okmarts.com will share with you, there are some problems that should be paid attention to when using it!
1. Transportation and storage matters
1. When unloading from the truck, use a double forklift and pay full attention to safety. Small cabinets should be supported by someone; or when they are lifted by a crane, use a steel cable or steel with a diameter of 10mm or more at the designated position. Bring it down safely;
2. When moving the cabinet, do not use excessive force or severe vibration, etc., to damage the feet and other parts;
3. Make sure to remove all the protective film of the outer packaging before use. The editor of okmarts.com tells everyone that after unpacking, it must be placed on a flat ground and placed horizontally;
2. Applicable environment of ultra-low temperature storage box
The distance between the periphery of the cabinet and the wall and other objects should not be less than 30 cm to ensure good heat dissipation of the condenser;
Avoid placing the cabinet in a leaking, water leaking or humid place;
Ensure that the use environment is dry and well ventilated, not close to heat sources, and avoid direct sunlight, so as not to affect the cooling effect;
Ultra-low temperature storage box cannot be used in flammable and explosive gas environment. Do not spray paint, paint and other flammable materials near the box to avoid fire.
Three, ultra-low temperature storage box electrical precautions
1. In order to ensure the normal operation of the ultra-low temperature storage box, please be sure to use a 220V power supply and a three-hole socket above 10A (try not to use a terminal block socket);
2. The ultra-low temperature series products belong to the design of wide voltage band. The power supply is 187V~242V/50Hz. The editor of the ultra-low temperature freezer tells everyone that if the voltage fluctuates too much, an automatic voltage stabilizer above 1250VA should be installed to avoid damage to the compressor and other electrical components. ;
3. When plugging or unplugging the power cord, use the hand-held plug instead of pulling the power cord;
4. A reliable and separate grounding wire must be installed for the ultra-low temperature storage box. The grounding wire must not be connected to gas pipes, heating pipes, water pipes, and the neutral wire of a single-phase power supply must not be borrowed;
5. If you need to lengthen the power cord, the cross-sectional area of the wire is ≥1.5mm2, and the wire can be single-stranded or multi-stranded. It is strictly forbidden to use multi-purpose sockets for connection.
Four, storage precautions
Note: Ultra-low temperature refrigerators are storage equipment, which is different from quick-freezing equipment. Do not put relatively hot items at one time, otherwise it may cause the compressor to work for a long time without stopping, the temperature does not drop and the compressor is easy to burn;
1. Before storing food or articles in the cabinet, the editor of okmarts.com ultra-low temperature storage box tells everyone that the empty box must be energized and reach the set temperature before putting the article;
2. The items or other products put into the box at one time should not exceed one-third of the volume of the box, and it should not be over-squeezed, and proper clearance should be ensured to facilitate the circulation of cold air in the box;
3. If the stored items have a large water content, appropriately reduce the amount of each time when placing the items.
Five, daily maintenance
1. Cabinet cleaning: After the power is off, clean the inner and outer surfaces of the ultra-low temperature storage box and apply a non-corrosive neutral detergent. After cleaning, wipe it with a dry cloth.
Note: It is strictly forbidden to directly wash the inner and outer surfaces of the box with water, so as not to affect the electrical insulation performance. It is strictly prohibited to use boiled water, decontamination powder, acid, alkali, gasoline, alcohol, benzene, corrosive detergent, and hard brush for cleaning.
2. When the ultra-low temperature storage box is running for a long time, frost is easy to accumulate at the door seal, the cabinet opening and the inner side wall of the box. If the frost layer is too thick, it will affect the sealing performance and refrigeration performance. Please use a defrosting scoop to defrost regularly and wipe it with a dry cloth. .
3. Clean the inner and outer surfaces of the storage box with a non-corrosive neutral cleaning agent. After cleaning, wipe with a dry cloth.
4. Use a soft brush or vacuum cleaner to regularly remove the dust on the condenser to maintain a good condensation effect;
5. When the storage box is out of service, unplug the power plug, clean it according to the above method, put it in a plastic bag after natural drying, and place it in a well-ventilated place.
After you have purchased the ultra-low temperature storage box from okmarts.com, you must read this precaution in advance to avoid any accidents!
Precautions for the use of ultra-low temperature storage boxes
Recent related posts
-
08/12/2020
Precautions for the use of ultra-low temperature storage boxes
The ultra-low temperature storage box is shipped after more than 12 hours of debugging before leaving the factory. Today, the editor of the ultra-low temperature storage box okmarts.com will share with you, there are some problems that should be paid atte¨ﰨ2 䀀 湠疨 V ǜ
-
08/12/2020
Precautions for construction and operation of cold storage
1. Matters needing attention during cold storage installation<br></br> 1. When installing a cold storage, in order to maintain a certain low temperature, a certain thickness of insulation material must be laid on the floor, walls and flat roof of the ¨ﰨ2 䀀 湠疨 V ǜ V 㠠Ǒ㠠Ǒ㠠Ǒ類 湠疨疜筦
-
08/12/2020
Performance factors of screw chiller combination accessories
The compressor is the core of the chiller. The performance provided by the compressor directly affects the performance of the entire chiller, and the performance index of the compressor directly determines and limits the performance of the chiller.
-
08/12/2020
Operation method of air discharge in refrigeration system of industrial chiller
Air is a non-condensable gas, which means that air will not condense into liquid at ordinary low temperatures. If air is mixed into the refrigeration system of an industrial chiller, it will affect the heat dissipation of the condenser and increase the co¨ﰨ2 䀀 湠疨 V
-
08/12/2020
Method for cleaning and protecting plates of plate heat exchanger
In addition to maintenance under special circumstances, the plate heat exchanger should also be regularly maintained. Due to the convenient disassembly and assembly of the plate heat exchanger and simple maintenance, special tools and equipment are genera¨ﰨ2 䀀 湠疨
-
08/12/2020
Matters needing attention when choosing evaporator for chiller
The evaporator is one of the four major components of the refrigeration system, and it is the ultimate manifestation of the cooling effect and efficiency. The evaporator is generally designed and equipped by the chiller manufacturer
-
08/12/2020
Master the following skills to make brazing easier
Brazing is a type of brazing. When the melting point of the flux is high, it is called brazing, such as brazing; there are three types of brazing, and the other two are not explained! Brazing is a good method for high-strength, leak-free connection
-
08/12/2020
It is also a refrigeration equipment, why does the refrigerator not need to add fluoride
Whether in summer or winter, air conditioners are people's good partners, especially in the hot summer, everyone can say that this life is given by air conditioners.
-
08/12/2020
How to prevent the refrigeration compressor from reversing
Reverse rotation is strictly prohibited after the refrigeration compressor is stopped. When the compressor rotor is stationary, there is still a large volume of process gas remaining in the pipeline and has a certain pressure
-
08/12/2020
How to pay attention to fire safety during construction and maintenance of cold storage
The focus of cold storage fire protection should be placed on the construction and maintenance of cold storage.
Customers frequently viewed
IWAYA DENKI Water Pump 25CJT0752
Panasonic Servo Motor MHMF022L1V2M
Honeywell Solenoid Valve VE4025B1045
ROTEN Mechanical Seal 8E5K-22-X
Schneider Sensor XS8E1A1PAL5
PIZZATO Switch FM 257-M2R24
NXQ Accumulator NXQA-10/20-L-Y