What should I do with the chiller at the end of the year

What should I do with the chiller at the end of the year After a year of non-stop operation of the chiller, more or less debris will be generated, and it will be attached to the evaporator, condenser, cooling tower water system or filter, and the refrigerant oil will also be contaminated, which is bound to affect The cooling effect of the chiller, therefore, we need to maintain the chiller, which can not only improve the working efficiency of the chiller in time, but also extend the service life of the chiller. Regarding the specific maintenance work items of the chiller, the editor of okmarts.com suggests that it can be completed from the following parts. 　　 One, check whether the chiller is malfunctioning Under normal circumstances, the chillers used in the factory (including screw chillers, air-cooled chillers, water-cooled chillers, low-temperature chillers, open chillers, etc.) are operated 24 hours a day. Since then, there will be some chillers. A variety of failures may occur if the quality is slightly poor. Therefore, the chiller factory recommends that before using the chiller on a daily basis, the first thing to do is to effectively eliminate the fault, perform the overhaul of the whole machine, check whether the power switch is normal, check whether the safety condition of the fuse is good, and whether the other parts of the chiller are connected Normally, make sure that everything is long before it starts to run. After using the chiller, you must also perform certain checks to see if there are any malfunctions caused by the use. If it is found, the chiller should be overhauled in time. 　　 2. Properly start and stop the chiller Many of the chillers used by customers (including screw chillers, air-cooled chillers, water-cooled chillers, low-temperature chillers, open chillers, etc.), many of the failures are caused by operating errors, which shows that the chillers start And shutdown are very important. Poor startup may affect the service life of the chiller. The chiller factory suggests that the chiller should be started and shut down correctly to effectively maintain the chiller and increase the service life. 　　 3. Clean the chiller when not in use 　　 The cleaning of the chiller is an important aspect of maintaining the chiller. When the chiller (including screw chiller, air-cooled chiller, water-cooled chiller, low-temperature chiller, open chiller, etc.) is not in use for a long time, all parts of the chiller should be cleaned and filtered. After the net surface is cleaned and maintained in all aspects, the chiller can be packaged to prevent dust and other debris from entering the chiller. 　　 As for the cleaning of the chiller, the editor of okmarts.com recommends regular cleaning, at least once a month. Cleaning can effectively remove dirt and improve the working efficiency of the chiller. 　　 Doing the above three points can ensure the normal operation of the chiller to the greatest extent and extend the service life of the chiller, so that the chiller can continue to cool and achieve the goal of improving production efficiency.