Omron Sensor E2B-M30LN20-WZ-C1

03/02/2021

Connection between Arduino and servo motor

The connection of the servo motor using Arduino is as follows: Connect the black wires on the two servo motors to the GND on the Arduino Connect the red wires on the two servo motors to the 5V pin on the Arduino Connect the yellow wire on the first motor to pin 8 on the Arduino

07/20/2020

How to judge the starter of the refrigerator compressor is broken

1. The heavy hammer starter, the part that is easily damaged is the poor contact of the start contact. During the measurement, the weight starter can be removed and measured with a multimeter ohm block according to the original installation direction.

11/02/2022

Detailed Classifications and Features of Electric Motors

Electric motors play an irreplaceable role in production, transmission and distribution. Each of them has their own structures, working principles, types of source power and applications.

09/05/2020

The pipeline is not working well, and the compressor is exhausted

Many users have invested a lot of energy and money in the selection, operation and maintenance of compressor equipment, but due to negligence on the compressed air pipeline, a lot of waste has been caused.

09/05/2020

Why screw air compressor can gradually replace piston machine

Screw air compressors and piston air compressors can be said to be the two models with the highest share of the current air compressor market. In the past, piston type air compressors were basically used.

09/09/2020

The pharmaceutical industry's requirements for compressed air quality are so rigorous!

The compressed air of pharmaceutical companies is mainly used for filling machines in liquid preparations, granulators, pulping machines, filling machines, packaging machines, printing machines in solid preparations, extraction tanks in the extraction process, and in addition Trial gas, powder material transportation, drying, blowing and purging, pneumatic instrument components, automatic control gas, etc.

11/26/2021

Why DC 4~20mA is Chosen for Signal Transmission of Transmitters?

In industry, it is necessary to measure all kinds of electric and non electric parameters, such as current, power, temperature, pressure, speed and angle, etc.

09/11/2020

Bearing and shaft fit tolerance standard

Bearing and shaft fit tolerance standard ①When the bearing inner diameter tolerance zone and the shaft tolerance zone form a fit, the tolerance code originally belonging to the transition fit in the general basic hole system will become an over-win fit, such as k5, k6, m5, m6, n6, etc., but the over-win amount is not Large; when the bearing inner diameter tolerance is matched with h5, h6, g5, g6, etc., it is not a clearance but an over-win fit.

08/15/2020

The price of industrial chiller is too low, what should you pay attention to

Industrial chillers are commonly used temperature control equipment and are used in various industries. Therefore, the requirements for use are also different. The requirements for laser and

06/14/2020

Danfoss cocuses on providing energy efficient, sustainable and smart refrigeration compressors for a varied range of commercial applications such as cold rooms