Rockwell AB VFD Frequency Converter 20BC1P3A0AYNANB0

08/13/2020

How to select the chiller and what should be paid attention to when using the evaporator

For customers who have used water chillers, the selection of water chillers is already familiar, and they are all aware of the various requirements. For customers who buy a chiller for the first time, they may not know too much about the size of the chillPﰨ2䀀

06/30/2022

What is Check Valve

Check valves are found in almost every industrial application acting as one-way or non-return valves.

09/23/2020

Automatic control scheme for multiple adsorption dryers and air compressors

With the development of modern industry and the improvement of automation level, various industries have higher and higher requirements for air supply, purification level, automatic control, and continuous and reliable air supply of air compressor stations.

06/29/2020

Suggestions for troubleshooting of compressor with liquid start

09/20/2020

Rolling bearing technology

Rolling bearing technology Rolling bearing temperature 　<br></br>　 The main factors of bearing operating temperature:

08/15/2020

Summer chiller failure detection and solutions

The weather is getting hotter and hotter, and the industrial chillers of many factories ushered in the peak period of refrigeration. Frequent operation of refrigeration equipment is likely to have such and other small failures.

06/14/2020

Refrigeration compressor installation conditions and precautions

The selection of the installation site is ignored by the staff. Often the compressor will be found at random after it is purchased and used immediately after piping.

07/17/2020

Cold storage installation and cold storage installation selection

First, the cold storage installation should pay attention to the following: the type of cold storage 1, according to temperature: A, high temperature cold storage (plus or minus 5 degrees Celsius): suitable for fruit and vegetable preservation; B, medium temperature cold storage (minus 10 degrees-minus 5 degrees):

09/05/2020

Who has the final say on equipment shutdown for maintenance

In enterprises, the equipment should be subject to preventive maintenance. According to the set cycle, the equipment should be shut down for repair. Usually production scheduling has the final say.

06/20/2020

How to properly clean the air conditioner yourself

After a winter of inactivity, the air conditioner that has been "dusted" for a long time is reactivated. It is believed that most of the friends are directly plugged in and turned on. In fact, this is not correct. <img src="{{media url=&quot;How_to_properly_clean_the_air_conditioner_yourself.jpg&quot;}}" alt="" /> It is necessary to know that the air conditioner has accumulated dust and breeds bacteria after being left for a long time. Blowing out with the wind seriously threatens your health. This is actually due to the working principle of the air conditioner: when cooling, the room temperature air is continuously sucked in, filtered by the filter, and then cooled by the fins of the heat exchanger, and finally the cold air is blown out, and then returned to the room for reciprocating circulation.