SHAKO Air Cylinder IC80B1000

09/08/2020

Dew point of adsorption dryer and its influencing factors

1. Adsorbent Adsorbent is the material basis of the adsorption dryer. The type of adsorbent has a decisive influence on the final dew point of the compressed air being processed. At present, the most commonly used adsorbents in compressed air dehydration and drying are silica gel,

07/05/2020

Notes on long-term shutdown of Hitachi air compressors during long holidays

Notes on long-term shutdown of Hitachi air compressors during long holidays Thank you very much for your strong support for Hitachi Air Compressor sales and after-sales service!

09/14/2020

Several PTA equipment process routes and equipment air compressor technology

PTA is the abbreviation of Purified Terephthalic Acid. PTA is the basic material for the production of polyester fiber and packaging industry, and the main raw material for the chemical fiber industry.

07/19/2022

What is Diaphragm Pumps

A diaphragm pump (also known as a Membrane pump) is a positive displacement pump that uses a combination of the reciprocating action of a rubber

09/04/2020

How to choose the dryer of screw air compressor

As everyone knows, when the screw air compressor is used for air supply, it is also necessary to configure relative post-processing purification equipment, because the compressed air directly discharged from the air compressor is not pure.

03/11/2021

The main circuit fuse fusing is a common fault of SCR servo driver. The causes of fuse fusing are as follows

The "phase sequence" of power incoming line is incorrect. Due to the synchronization problem between the trigger pulse and the main circuit of SCR servo driver, there are strict requirements on the "phase sequence" of the input power supply. If the "phase sequence" is not correct, connecting the power supply may immediately cause the fuse of the main circuit of the driver to blow.

07/08/2020

How to solve the problem of poor oil return of screw chiller

1. What is the cause of the poor oil return of the screw chiller? 　　 Generally speaking, the reason for the poor oil return of the screw chiller is mainly due to the phenomenon of the gas mixture of lubricating oil and refrigerant during the operation. Specifically, in the operation of the refrigeration system, encountering the miscibility of the refrigerant and the refrigerator lubricating oil will cause the lubricant in the refrigeration compressor to run and the refrigerant will be discharged into the condenser in the form of gas mist and droplets.

07/27/2020

Ten reasons for the burning of air conditioning compressors

During the starting process of the air conditioner compressor, there is generally a step-down starting circuit, but the starting current will exceed several times the rated current, and the starting temperature of the air conditioner compressor motor will rise very quickly.

06/29/2020

What is the cause of compressor pipeline vibration

08/28/2020

How to avoid microorganisms in compressed air

Did you know that microorganisms thrive in humid environments, and humid environments can be created by compressing the atmosphere? This means that in the food and beverage industries,