UniOhm Resistor 1206W4F200LT5E

08/05/2020

The most common refrigeration method in the market and detailed description

1. Vapor compression refrigeration cycle 　　Using the latent heat generated by the phase change of the working fluid, refrigeration is realized through a closed cycle of compression, condensation, throttling, and evaporation.

01/10/2021

Auto repair case Air conditioner compressor does not work after Mitsubishi Pajero overhaul Vehicle Information

Auto repair case Air conditioner compressor does not work after Mitsubishi Pajero overhaul Vehicle Information The Mitsubishi Pajero off-road vehicle uses a 6G72 engine. The air-conditioning compressor does not work after the car is overhauled and t器2䀀
ￜ皥
䖒

08/19/2020

How much does it cost to build a cold storage

The cold chain has been naturally pushed to the forefront of the storm and has become a hot topic in the food logistics industry. The construction of a cold chain system is of great significance.

09/09/2020

The influence of machining on fatigue life

The residual compressive stress introduced by shot blasting/shot peening is a percentage of the final tensile stress strength, and this ratio increases as the strength/hardness of the part material itself increases. High-strength/hardness metals are more brittle and more sensitive to surface defects. Shot blasting/shot peening will allow these high-strength metals to be used in fatigue-prone working conditions. Aircraft landing gear is usually designed with a fatigue strength of 300 ksi (2068 MPa), combined with shot blasting/shot peening.

01/17/2025

Why Does Servo Motor Vibrate?

In which cases will a servo motor vibrate? What happens if the servo motor vibrates? How can we solve the problems caused by the vibration? This article will explain various reasons for this.

06/29/2020

Several causes of compressor burning

08/18/2020

Solution to water leakage of fan coil ceiling

The fan-coil system is supplied with chilled water by the chiller, and the water temperature is usually only about 8°C. Therefore, the chilled water supply and return pipes, condenser pipes and condensate trays are all relatively low in temperature.

07/16/2020

Limitations of motor protectors

The main purpose of motor protection is to protect the motor from burning, and the function of the protector is very limited, which is obviously an impossible task. In practical applications, there are many reasons that can cause the motor to burn down, which can be roughly divided into the following categories: motor overload caused by various

12/19/2024

Mitsubishi Servo Drive Fault Codes and Troubleshooting Methods

Mitsubishi servo system consists of servo motor, controller, and servo drive (also called servo amplifier), mainly including MR-J2S series, MR-J series, MR-H series, MR-C series, MR-J2 series, MR-J2S series, MR-E series, MR-J3 series, MR-ES series, MR-JE series, MR-J4 series, etc.

08/14/2020

How much do you know about water-cooled chillers A few steps let you know

What is the cooling method of the chiller? A water-cooled chiller is one of them. It has many names. Some people say it is a chiller or a chiller. No matter which type, it is the same machine.