Baumer Sensor OPDK 14N3901/S35A

09/14/2020

What are the reasons for the high temperature of the air compressor

The air compressor is a transmission machine. If the equipment running at high speed is not properly lubricated or cooled, it will inevitably produce high temperature. Excessive temperature will cause changes in the physical coefficient values ​​of the rotor and bearing materials, and in severe cases, the entire main engine will bite.

04/05/2024

Analysis and Solutions to AC Servo Motor Vibration Faults

AC servo motors are used in closed environments and are usually not easily damaged. But if the AC servo motor has vibration failure, what is the reason?

07/30/2020

What should be paid attention to to make cold storage more energy-efficient?

1. The index to reduce the unit heat flow of the enclosure structure of the cold storage. In the design of the cold storage, the unit heat flow q of the outer wall of the low-temperature cold storage is generally about 11.63W.

08/09/2023

Why is My Heat Pump Icing Up? Understanding the Causes and Solutions

Heat pumps are an essential household appliance that is used to regulate room temperature all year round. They are designed to extract heat from the ground or air outside and transfer it inside the home to keep it warm during the winter and cool during the summer.

03/02/2022

Factors Affecting Air Compressor Performance in Long-Period Operation

Through the research on the use and periodic failure factors of compressors in recent years, it is known that bearing clearance.

03/02/2021

Connection between Arduino and servo motor

The connection of the servo motor using Arduino is as follows: Connect the black wires on the two servo motors to the GND on the Arduino Connect the red wires on the two servo motors to the 5V pin on the Arduino Connect the yellow wire on the first motor to pin 8 on the Arduino

07/18/2020

Working condition and adjustment of refrigeration system of low temperature chiller

Low-temperature chiller refrigeration system operating conditions and adjustments Nowadays, chillers are widely used in the refrigeration industry, and the refrigeration working fluid is usually R22 (also R404a) and so on. In order to facilitate operation and maintenance and reduce the installation location, the refrigeration compressor

06/14/2020

Single screw compressor

Single screw compressor

06/14/2020

Danfoss cocuses on providing energy efficient, sustainable and smart refrigeration compressors for a varied range of commercial applications such as cold rooms

08/05/2020

Do you know all the protective devices for air-cooled chiller refrigeration compressors

In order to prevent the air-cooled chiller from running uninterruptedly for 24 hours, causing the compressor to operate under high load, the electromagnetic switch is not good, the overcurrent caused by the shaft holding,