Turck Sensor BI8U-Q08-AN6X2

07/16/2020

Analysis of the reason why cold storage should not be built underground

Many people think that building cold storage underground will have better thermal insulation effect than cold storage on the ground, because in the past, when the technology was backward, it was very common to choose cellars as crop storage. But from a commercial point of view, it is not scientific to blindly build the cold storage underground. The cold storage construction team stands from the perspective of consideration for customers

08/17/2020

Structural requirements of modular air conditioning units

1. When the windward velocity of the cooling coil exceeds 2.5m/s, a water baffle shall be set. 　　2, the spray section should have an observation window, a water baffle and a water filter device.

07/07/2020

Earth Hour: Hitachi Central Air Conditioner works with you to speak for the earth

01/10/2021

Don't understand the compressor It's enough to see these

Don't understand the compressor It's enough to see these Many people say that buying an air conditioner means buying a compressor. This is true. Simply put, the quality and life of the compressor determine the attitude of most people to buy. So what are 器2䀀
ￜ皥
䖒皦즠Ʋ㎄ᰙ㲈Ʋ
䌁皦
ᮔDž༬皧㎎ᰙЀ呄ᠾ鹨់༹皧
ࠄ
00령ꐱ댁珵뛐珵Љ
䕄ྦ￿￿뤂ᐱ뚜珵

06/14/2020

The cold storage was built in this way, which actually saved nearly half of the electricity bill!

Compared with the ordinary refrigerator, the cold storage has a larger cooling area, and because of the large cooling area of ​​the cold storage, the power consumption is relatively large.

08/24/2020

What kind of equipment is suitable for high and low pressure refrigerant charging method

There are generally two types of refrigerant charging methods: low-pressure charging and high-pressure charging. The advantage of the low pressure charging method is that it is easier to control the amount of refrigerant charged,

09/09/2020

The influence of machining on fatigue life

The residual compressive stress introduced by shot blasting/shot peening is a percentage of the final tensile stress strength, and this ratio increases as the strength/hardness of the part material itself increases. High-strength/hardness metals are more brittle and more sensitive to surface defects. Shot blasting/shot peening will allow these high-strength metals to be used in fatigue-prone working conditions. Aircraft landing gear is usually designed with a fatigue strength of 300 ksi (2068 MPa), combined with shot blasting/shot peening.

09/10/2020

The actual displacement of the screw compressor is affected by those factors

1) Leakage. There is no contact between the rotors and between the rotor and the housing during operation, and a certain gap is maintained, so gas leakage will occur. When the pressure increased gas leaks to the suction pipe and the sucking groove through the gap, the exhaust volume will be reduced.

08/20/2020

Precautions when the FRP cooling tower is assembled and ready for operation

When the FRP cooling tower is assembled and ready for normal operation, the following necessary inspections should be done first:

11/25/2024

Troubleshooting a Split AC Not Cooling But Fan is Running (12 Possible Reasons)

A split air conditioner, known for its efficiency and comfort, can be a savior during the scorching summer months.