Several details in the cold storage installation process

Several details in the cold storage installation process

Hello, dear readers and friends, today the editor of okmarts.com will briefly introduce you to several details of the cold storage installation process.

　　 1. Copper pipe discharge

　　 Try to use straight pipes and fix them in sections. All copper pipes need to be wrapped with insulation pipes and wires in the same direction with air-conditioning straps. The joints of insulation pipes and insulation pipes shall be tightly sealed with electrical tape.

　　2, wire discharge

　　 need to be protected by corrugated hoses or wire troughs. All wires are tied up with air-conditioning ties. Temperature display wires should not be placed close to the wires.

　　3, cold storage installation refrigeration system connection

When opening, because the condenser and evaporator of the main engine are pressed and sealed in the factory. There should be pressure, and it can be checked for leaks. The copper pipes should be sealed at both ends of the factory, and they should be sealed at any time during construction to prevent dust. Enter the tube, condenser → host → evaporator, the copper tube is connected by welding, and the interface is firm and beautiful. The wire diameter meets the requirements, and the wire is configured according to the performance of each electrical appliance. The connector is firm, and the maintenance is required to pass through the tube. correct.

　　4, radiator cold storage installation

It is best to place the radiator on the upper side of the host, and the radiator is placed as close to the host as possible. The radiator device has the best heat dissipation environment, and the air inlet cannot be facing the air outlet of other equipment, especially oily gas, and the air outlet cannot be short-circuited or faced. Other windows (especially residential windows) and equipment should be 2M above the ground and the installation level should be firm.